10 material differences · fewer than 12

Tractor oneFiat 70-66 F (DT/F)1984–1991No measured PTO figureTractor twoFiat 70-90 (DT)1984–1992No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (57%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

10 material differences · 5 fields identical or within 5%, which is not counted as material

Fiat 70-66 F (DT/F) and Fiat 70-90 (DT), field by field
Field70-66 F (DT/F)70-90 (DT)Gap
Engine
Engine power, claimed claimed69.1 hp69.1 hp—
Engine declaredFIAT-IVECO 8045.06.206 or 306FIAT-IVECO 8045.06.200 or 300differs
Displacement declared3.61 L3.61 L—
Maximum torque declared165 lb·ft · 224 N·m168 lb·ft · 228 N·m—
Transmission
Top speed declared18.6 mph · 30 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declaredDry Valeo or LuK double clutchDry VALEO, O.M.G. or LuK double clutchdiffers
Hydraulics & hitch
Pump flow declared8.7 gpm · 32.8 L/min9.4 gpm · 35.5 L/min+8% 70-90 (DT)
Pressure declared3,046 psi · 210 bar3,046–3,118 psi · 210–215 bar—
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared4,277 lb · 1,940 kg6,702 lb · 3,040 kg+57% 70-90 (DT)
Maximum permissible mass declared—11,684 lb · 5,300 kg—
Wheelbase declared78.8 in · 2,001 mm92.2 in · 2,342 mm+17% 70-90 (DT)
Length declared121.7 in · 3,090 mm152.9 in · 3,884 mm+26% 70-90 (DT)
Width declared65.7 in · 1,670 mm76.0–99.6 in · 1,930–2,530 mmdiffers
Ground clearance declared17.1 in · 435 mm19.9 in · 505 mm+16% 70-90 (DT)
Turning radius, braked declared—11.4 ft · 3.48 m—
Fuel tank declared52.8 qt · 50.0 L98.3 qt · 93.0 L+86% 70-90 (DT)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Fiat 70-66 F (DT/F) sources

Source
  • Source: Traktorenlexikon, “Fiat 70-66 F/70-66 F/DT”
  • Source: Traktorenlexikon, “Fiat 70-66/70-66 DT”

Fiat 70-90 (DT) sources

Source
  • Source: Traktorenlexikon, “Fiatagri 70-90/70-90 DT”