11 material differences · fewer than 12

Tractor oneFiat 65-56 LM (DT)from 1988No measured PTO figureTractor twoLandini 6560 L (DT) TL 37 N/M (TL-37 DT/M)1988–2000No measured PTO figure

Which should you choose?

Read our verdict on the 65-56 LM (DT) and the 6560 L (DT) TL 37 N/M (TL-37 DT/M) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

11 material differences · 6 fields identical or within 5%, which is not counted as material

Fiat 65-56 LM (DT) and Landini 6560 L (DT) TL 37 N/M (TL-37 DT/M), field by field
Field65-56 LM (DT)6560 L (DT) TL 37 N/M (TL-37 DT/M)Gap
Engine
Engine power, claimed claimed64.1 hp64.1 hp—
Engine declaredFiat 8045.06.220 or 320Perkins A 4.236differs
Displacement declared3.61 L3.87 L+7% 6560 L (DT) TL 37 N/M (TL-37 DT/M)
Maximum torque declared151 lb·ft · 205 N·m181 lb·ft · 245 N·m+20% 6560 L (DT) TL 37 N/M (TL-37 DT/M)
Transmission
Top speed declared18.6 mph · 30 km/h18.6 mph · 30 km/h—
Clutch declaredDry LuK or VALEO double clutchDry and air-cooled OMG double clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared8.7 gpm · 32.8 L/min11.2 gpm · 42.3 L/min+29% 6560 L (DT) TL 37 N/M (TL-37 DT/M)
Pressure declared3,046 psi · 210 bar2,756 psi · 190 bar+11% 65-56 LM (DT)
Three-point lift, at the coupling points declared3,847 lb · 1,745 kg4,630 lb · 2,100 kg+20% 6560 L (DT) TL 37 N/M (TL-37 DT/M)
Rear PTO speeds declared540 rpm540 rpm / 1000 rpmdiffers
Weight & dimensions
Unladen weight declared5,004 lb · 2,270 kg5,004 lb · 2,270 kg—
Wheelbase declared85.3 in · 2,167 mm81.5 in · 2,070 mm—
Length declared141.7 in · 3,600 mm140.6 in · 3,570 mm—
Width declared71.7–91.3 in · 1,820–2,320 mm65.7–87.4 in · 1,670–2,220 mmdiffers
Ground clearance declared18.9 in · 480 mm16.5 in · 420 mm+14% 65-56 LM (DT)
Turning radius, braked declared11.5 ft · 3.51 m10.8 ft · 3.29 m+7% 65-56 LM (DT)
Fuel tank declared63.4 qt · 60.0 L65.5 qt · 62.0 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Fiat 65-56 LM (DT) sources

Source
  • Source: Traktorenlexikon, “Fiatagri 65-56 LM (DT)”

Landini 6560 L (DT) TL 37 N/M (TL-37 DT/M) sources

Source
  • Source: Traktorenlexikon, “Landini R 6560 L (DT)”
  • Source: Traktorenlexikon, “Massey Ferguson MF 168 & MF 168A”