11 material differences · fewer than 12
Tractor oneFiat 550 (DT)1968–1978No measured PTO figureTractor twoInternational Harvester 5441968–1973No measured PTO figure
Which should you choose?
Read our verdict on the 550 (DT) and the 544 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 550 (DT) | 544 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 51.2 hp | 51.2 hp | — |
| Engine declared | FIAT-IVECO 8045 | INTERNATIONAL HARVESTER C-200 | differs |
| Displacement declared | 3.12 L | — | — |
| Maximum torque declared | 137 lb·ft · 186 N·m | 171 lb·ft · 232 N·m | +25% 544 |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 544 |
| Clutch declared | Dry FEREDO double clutch with separate PTO control | Pedal operated dry single plate clutch type 11 inches | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 21.8 L/min | 12.0 gpm · 45.4 L/min | +108% 544 |
| Pressure declared | 2,843 psi · 196 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,542 lb · 2,060 kg | 4,978 lb · 2,258 kg | +10% 544 |
| Wheelbase declared | 81.5 in · 2,070 mm | 73.0 in · 1,854 mm | +12% 550 (DT) |
| Length declared | 135.0 in · 3,430 mm | 138.0 in · 3,505 mm | — |
| Width declared | 66.5–95.3 in · 1,690–2,420 mm | 71.0 in · 1,803 mm | differs |
| Ground clearance declared | 16.5 in · 420 mm | 11.0 in · 279 mm | +51% 550 (DT) |
| Turning radius, braked declared | 10.3 ft · 3.13 m | 10.5 ft · 3.20 m | — |
| Fuel tank declared | 57.1 qt · 54.0 L | 132.1 qt · 125.0 L | +131% 544 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 550 (DT) sources
- Source: Traktorenlexikon, “Fiat 550/550 DT”
International Harvester 544 sources
- Source: Traktorenlexikon, “IHC 544”