8 material differences · fewer than 12

Tractor oneFiat 540 Spezial (DT)1973–1980No measured PTO figureTractor twoFiat 540 V/E1973–1982No measured PTO figure

Which should you choose?

We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

8 material differences · 7 fields identical or within 5%, which is not counted as material

Fiat 540 Spezial (DT) and Fiat 540 V/E, field by field
Field540 Spezial (DT)540 V/EGap
Engine
Engine power, claimed claimed53.2 hp53.2 hp—
Engine declaredFIAT-IVECO 8035.02.204FIAT-IVECO 8035.02.202/304differs
Displacement declared2.59 L2.59 L—
Maximum torque declared124 lb·ft · 168 N·m124 lb·ft · 168 N·m—
Transmission
Top speed declared15.5 mph · 25 km/h12.4 mph · 20 km/h+25% 540 Spezial (DT)
Clutch declaredDry LuK double clutchDry LuK double clutch—
Hydraulics & hitch
Pump flow declared6.2 gpm · 23.6 L/min5.8 gpm · 21.8 L/min+8% 540 Spezial (DT)
Pressure declared—2,843 psi · 196 bar—
Rear PTO speeds declared540 rpm540 rpm—
Weight & dimensions
Unladen weight declared4,189 lb · 1,900 kg3,527 lb · 1,600 kg+19% 540 Spezial (DT)
Maximum permissible mass declared7,937 lb · 3,600 kg——
Wheelbase declared75.6 in · 1,920 mm74.2 in · 1,885 mm—
Length declared117.1 in · 2,975 mm125.2 in · 3,180 mm+7% 540 V/E
Width declared68.5–87.2 in · 1,740–2,215 mm38.9–53.9 in · 989–1,370 mmdiffers
Ground clearance declared18.9 in · 480 mm13.0 in · 330 mm+45% 540 Spezial (DT)
Turning radius, braked declared11.2 ft · 3.40 m9.6 ft · 2.93 m+16% 540 Spezial (DT)
Fuel tank declared57.1 qt · 54.0 L57.1 qt · 54.0 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Fiat 540 Spezial (DT) sources

Source
  • Source: Traktorenlexikon, “Fiat 540 Special/540 Special DT”

Fiat 540 V/E sources

Source
  • Source: Traktorenlexikon, “Fiat 540 V/E”
  • Source: Traktorenlexikon, “Someca 540”