Fiat 45-66 V (DT/V) or Ford 3430?
Which should you choose?
On performance, no comparable figure differs by more than its threshold: on this data the machines are level. On features, the Fiat 45-66 V (DT/V) is ahead on forward gears and PTO speeds.
- The Fiat 45-66 V (DT/V) suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 1000 rpm.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 45-66 V (DT/V) | 3430 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 28.0 kW (37.5 hp)Traktorenlexikon, “Fiat 45-66 V/45-66 V/DT” | 28.1 kW (37.7 hp)Traktorenlexikon, “Ford 3430” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 45-66 V (DT/V) and the 3430. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 45-66 V (DT/V) and the 3430. |
| Which pumps more oil for implements? | — | 31.0 L/min (8.2 gpm)Traktorenlexikon, “Ford 3430” | No figureNo call on hydraulic flow: no figure on record for the 45-66 V (DT/V). |
| Which lifts more on the three-point hitch? | 1,800 kg (3,968 lb)Traktorenlexikon, “Fiat 45-66 V/45-66 V/DT” | 1,700 kg (3,748 lb)Traktorenlexikon, “Ford 3430” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 1,530 kg (3,373 lb)Traktorenlexikon, “Fiat 45-66 V/45-66 V/DT” | 2,742 kg (6,045 lb)Traktorenlexikon, “Ford 3430” | Ahead (a fact, not an advantage)The Ford 3430 is 79% heavier (1,212 kg / 2,672 lb) than the Fiat 45-66 V (DT/V) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 45-66 V (DT/V) and the 3430. |
| Which has the wider choice of gears? | 12 to 20Traktorenlexikon, “Fiat 45-66 V/45-66 V/DT” | 8Traktorenlexikon, “Ford 3430” | AheadThe Fiat 45-66 V (DT/V) has 50% more forward gears (4 gears) than the Ford 3430 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 45-66 V (DT/V) and the 3430. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Fiat 45-66 V/45-66 V/DT” | 30 km/h (18.6 mph)Traktorenlexikon, “Ford 3430” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Fiat 45-66 V/45-66 V/DT” | 540 rpmTraktorenlexikon, “Ford 3430” | AheadThe Fiat 45-66 V (DT/V) offers 1000 rpm at the PTO, which the Ford 3430 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Fiat 45-66 V/45-66 V/DT” | independentTraktorenlexikon, “Ford 3430” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 45-66 V/45-66 V/DT” | 2WD / 4WDTraktorenlexikon, “Ford 3430” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1985–1992 | 1990–1997 | Ahead (a fact, not an advantage)The Ford 3430 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Ford 3430 is 79% heavier (1,212 kg / 2,672 lb) than the Fiat 45-66 V (DT/V) (both unladen weight, as stated by the source).
- The Fiat 45-66 V (DT/V) has 50% more forward gears (4 gears) than the Ford 3430 (both forward gears, as stated by the source).
- The Fiat 45-66 V (DT/V) offers 1000 rpm at the PTO, which the Ford 3430 does not (as stated by the sources).
- The Ford 3430 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources