9 material differences · fewer than 12
Tractor oneFiat 400 (DT)1968–1974No measured PTO figureTractor twoZETOR 3511/35451967–1972No measured PTO figure
Which should you choose?
Read our verdict on the 400 (DT) and the 3511/3545 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | 400 (DT) | 3511/3545 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.5 hp | 34.5 hp | — |
| Engine declared | FIAT-IVECO 8035.01.201 | ZETOR Z-3001 | differs |
| Displacement declared | 2.34 L | 2.34 L | — |
| Maximum torque declared | 103 lb·ft · 140 N·m | 98 lb·ft · 133 N·m | +5% 400 (DT) |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal-operated two-stage dry Feredo double clutch | Foot-operated dry two-stage double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 21.8 L/min | 5.3 gpm · 20.0 L/min | +9% 400 (DT) |
| Pressure declared | 2,843 psi · 196 bar | 2,134 psi · 147 bar | +33% 400 (DT) |
| Three-point lift, at the coupling points declared | 2,866 lb · 1,300 kg | 2,205 lb · 1,000 kg | +30% 400 (DT) |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,750 lb · 1,701 kg | 3,373 lb · 1,530 kg | +11% 400 (DT) |
| Wheelbase declared | 75.6 in · 1,920 mm | 75.5 in · 1,918 mm | — |
| Length declared | 124.8 in · 3,169 mm | 128.6 in · 3,266 mm | — |
| Width declared | 62.4–88.2 in · 1,585–2,240 mm | 65.0 in · 1,652 mm | differs |
| Ground clearance declared | 14.6 in · 370 mm | 13.8 in · 350 mm | +6% 400 (DT) |
| Turning radius, braked declared | 9.7 ft · 2.95 m | 9.6 ft · 2.93 m | — |
| Fuel tank declared | — | 40.2 qt · 38.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 400 (DT) sources
- Source: Traktorenlexikon, “Fiat 400/400 DT”
ZETOR 3511/3545 sources
- Source: Traktorenlexikon, “Zetor 3511”