8 material differences · fewer than 12
Tractor oneFiat 1300 DT1973–1976No measured PTO figureTractor twoJ.I. Case 11751972–1978No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 1300 DT | 1175 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 130.3 hp | 121.9 hp | +7% 1300 DT |
| Engine declared | OM CP 3-100/Var. 16 | CASE A-451 T | differs |
| Displacement declared | 7.41 L | 7.39 L | — |
| Maximum torque declared | 356 lb·ft · 482 N·m | 384 lb·ft · 520 N·m | +8% 1175 |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | dry Ferodo single-plate clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.6 gpm · 47.7 L/min | 16.0 gpm · 60.6 L/min | +27% 1175 |
| Pressure declared | 2,901 psi · 200 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 12,192 lb · 5,530 kg | 10,199 lb · 4,626 kg | +20% 1300 DT |
| Maximum permissible mass declared | 16,535 lb · 7,500 kg | — | — |
| Wheelbase declared | 109.1 in · 2,770 mm | 108.0 in · 2,743 mm | — |
| Length declared | 180.3 in · 4,580 mm | 172.0 in · 4,370 mm | — |
| Width declared | 85.4 in · 2,170 mm | 88.0 in · 2,235 mm | — |
| Ground clearance declared | 16.7 in · 425 mm | 22.2 in · 565 mm | +33% 1175 |
| Turning radius, braked declared | 25.3 ft · 7.70 m | 12.8 ft · 3.91 m | +97% 1300 DT |
| Fuel tank declared | 211.3 qt · 200.0 L | 200.0 qt · 189.3 L | +6% 1300 DT |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 1300 DT sources
- Source: Traktorenlexikon, “Fiat 1300 DT”
J.I. Case 1175 sources
- Source: Traktorenlexikon, “Case 1175”
- Source: Traktorenlexikon, “Case 1170”