Fiat 110-90 (DT) or Hürlimann H-5110 (A)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 110-90 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the H-5110 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Hürlimann H-5110 (A) suits road haulage better on this data: 12% (800 kg / 1,764 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 110-90 (DT) | H-5110 (A) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 81 kW (109 hp)Traktorenlexikon, “Fiatagri 110-90 DT” | 80.9 kW (108.5 hp)Traktorenlexikon, “Hürlimann H 5110” | Not comparableNot comparable on power at the PTO shaft: the 110-90 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the H-5110 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 110-90 (DT) and the H-5110 (A). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 110-90 (DT) and the H-5110 (A). |
| Which pumps more oil for implements? | 57.0 L/min (15.1 gpm)Traktorenlexikon, “Fiatagri 110-90 DT” | — | No figureNo call on hydraulic flow: no figure on record for the H-5110 (A). |
| Which lifts more on the three-point hitch? | 4,537 kg (10,002 lb)Traktorenlexikon, “Fiatagri 110-90 DT” | 3,875 kg (8,543 lb)Traktorenlexikon, “Hürlimann H 5110” | Not comparableNot comparable on three-point lift: the 110-90 (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Fiatagri 110-90 DT”); the H-5110 (A): lift through the full range at the hitch ends, as stated by the source (Traktorenlexikon, “Hürlimann H 5110”) — not the same quantity, basis and condition. |
| Which is heavier, for traction? | 4,280 kg (9,436 lb)Traktorenlexikon, “Fiatagri 110-90 DT” | 4,300 kg (9,480 lb) to 4,800 kg (10,582 lb)Traktorenlexikon, “Hürlimann H 5110” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 6,500 kg (14,330 lb)Traktorenlexikon, “Fiatagri 110-90 DT” | 7,300 kg (16,094 lb)Traktorenlexikon, “Hürlimann H 5110” | AheadThe Hürlimann H-5110 (A) has 12% higher maximum permissible mass (800 kg / 1,764 lb) than the Fiat 110-90 (DT) (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 20Traktorenlexikon, “Fiatagri 110-90 DT” | 12 to 24Traktorenlexikon, “Hürlimann H 5110” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 110-90 (DT) and the H-5110 (A). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri 110-90 DT” | 25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Hürlimann H 5110” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Fiatagri 110-90 DT” | 540/1000 rpmTraktorenlexikon, “Hürlimann H 5110” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Fiatagri 110-90 DT” | — | No figureNo call on PTO independence: not stated for the H-5110 (A). |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri 110-90 DT” | Two-wheel or four-wheel driveTraktorenlexikon, “Hürlimann H 5110” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1986–2003 | 1979–1983 | Ahead (a fact, not an advantage)The Fiat 110-90 (DT) is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Hürlimann H-5110 (A) has 12% higher maximum permissible mass (800 kg / 1,764 lb) than the Fiat 110-90 (DT) (both maximum permissible mass, as stated by the source).
- The Fiat 110-90 (DT) is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the 110-90 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the H-5110 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- Not comparable on three-point lift: the 110-90 (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Fiatagri 110-90 DT”); the H-5110 (A): lift through the full range at the hitch ends, as stated by the source (Traktorenlexikon, “Hürlimann H 5110”) — not the same quantity, basis and condition.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources