5 material differences · fewer than 12
Tractor oneFendt Favorit 41966–1967No measured PTO figureTractor twoJohn Deere 40101960–1963No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD / 2WD; 2WD); they were not built in overlapping years (1966–1967; 1960–1963). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Favorit 4 | 4010 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 79 hp | 80 hp | — |
| Engine declared | — | Deere 380 CID | — |
| Displacement declared | — | 6.23 L | — |
| Maximum torque declared | 221 lb·ft · 300 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 19.9 mph · 32.0 km/h | +7% 4010 |
| Clutch declared | Single-plate dry clutch and upstream Voith hydrodynamic coupling | Dry double clutch for independent coupling of drive and power take-off | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 9.7 gpm · 36.8 L/min | 18.0 gpm · 68.0 L/min | +85% 4010 |
| Pressure declared | 2,489 psi · 172 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,055 lb · 3,200 kg | 6,980 lb · 3,166 kg | — |
| Maximum permissible mass declared | 14,330 lb · 6,500 kg | — | — |
| Wheelbase declared | 101.2 in · 2,570 mm | 99.2 in · 2,520 mm | — |
| Length declared | 152.4 in · 3,870 mm | 164.6 in · 4,180 mm | +8% 4010 |
| Width declared | 76.8 in · 1,950 mm | 92.5 in · 2,350 mm | +21% 4010 |
| Ground clearance declared | 18.1 in · 460 mm | — | — |
| Turning radius, braked declared | 13.9–16.2 ft · 4.25–4.95 m | — | — |
| Fuel tank declared | 137.4 qt · 130 L | 135.3 qt · 128 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Favorit 4 sources
- Source: Traktorenlexikon, “Fendt Favorit 4”
- Source: Traktorenlexikon, “Fendt Favorit 4 S/SA”
John Deere 4010 sources
- Source: Traktorenlexikon, “John Deere 4010”