7 material differences · fewer than 12
Tractor oneFendt Favorit 3s1967–1970No measured PTO figureTractor twoSOMECA 680 (TD)1978–1983No measured PTO figure
Which should you choose?
Read our verdict on the Favorit 3s and the 680 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Favorit 3s | 680 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 60.9 hp | 67 hp | +10% 680 (TD) |
| Engine declared | MWM D 225.4 | FIAT-IVECO 8045.02.270 (370) | differs |
| Displacement declared | 3.38 L | 3.46 L | — |
| Maximum torque declared | 157 lb·ft · 213 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% Favorit 3s |
| Clutch declared | Tornado duplex clutch by Fichtel & Sachs | Dry FERODO double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 6.8 gpm · 25.8 L/min | — |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,986 lb · 2,715 kg | 5,512 lb · 2,500 kg | +9% Favorit 3s |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | 89.0 in · 2,261 mm | 89.2 in · 2,265 mm | — |
| Length declared | 151.4 in · 3,845 mm | 154.3 in · 3,920 mm | — |
| Width declared | 73.5 in · 1,868 mm | 80.3 in · 2,040 mm | +9% 680 (TD) |
| Ground clearance declared | 16.5 in · 420 mm | 20.0 in · 508 mm | +21% 680 (TD) |
| Turning radius, braked declared | 12.1 ft · 3.70 m | 11.2 ft · 3.40 m | +9% Favorit 3s |
| Fuel tank declared | — | 84.5 qt · 80.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Favorit 3s sources
- Source: Traktorenlexikon, “Fendt Favorit 3 S/SA”
SOMECA 680 (TD) sources
- Source: Traktorenlexikon, “Someca 680”
- Source: Traktorenlexikon, “Fiat 680 /680 DT”