12 material differences
Tractor oneFendt Farmer 3101993–2001No measured PTO figureTractor twoVALMET 6600-4 (6600E)1991–2000No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD / 2WD; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
12 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Farmer 310 | 6600-4 (6600E) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 103 hp | 103.5 hp | — |
| Engine declared | MWM TD 226. B-4 | VALMET 420 DS (420 DSE) | differs |
| Displacement declared | 4.16 L | 4.40 L | +6% 6600-4 (6600E) |
| Maximum torque declared | 309 lb·ft · 419 N·m | 299 lb·ft · 405 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–31.1 mph · 30–50 km/h | differs |
| Clutch declared | — | Pedal operated dry Fichtel & Sachs single plate clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 19.8 gpm · 75.0 L/min | 21.2 gpm · 80.3 L/min | +7% 6600-4 (6600E) |
| Pressure declared | — | 2,031–2,248 psi · 140–155 bar | — |
| Rear PTO speeds declared | 540/750/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 10,803 lb · 4,900 kg | 9,700 lb · 4,400 kg | +11% Farmer 310 |
| Maximum permissible mass declared | 18,739 lb · 8,500 kg | 16,535 lb · 7,500 kg | +13% Farmer 310 |
| Wheelbase declared | 91.9 in · 2,333 mm | 91.6 in · 2,326 mm | — |
| Length declared | 164.6 in · 4,180 mm | 177.7 in · 4,514 mm | +8% 6600-4 (6600E) |
| Width declared | 89.8 in · 2,280 mm | 78.1–101.8 in · 1,985–2,585 mm | differs |
| Ground clearance declared | 21.1 in · 536 mm | 19.1 in · 485 mm | +11% Farmer 310 |
| Turning radius, braked declared | 13.1 ft · 4.00 m | 15.3 ft · 4.65 m | +16% 6600-4 (6600E) |
| Fuel tank declared | 142.7 qt · 135 L | 174.4 qt · 165.0 L | +22% 6600-4 (6600E) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Farmer 310 sources
- Source: Traktorenlexikon, “Fendt Farmer 310”
- Source: Traktorenlexikon, “Fendt Farmer 308”
VALMET 6600-4 (6600E) sources
- Source: Traktorenlexikon, “Valmet 6600”