9 material differences · fewer than 12
Tractor oneFendt Farmer 2 D1961–1967No measured PTO figureTractor twoHermann Lanz D 301956–1960No measured PTO figure
Which should you choose?
Read our verdict on the Farmer 2 D and the D 30 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Farmer 2 D | D 30 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 27.5 hp | 27.5 hp | — |
| Engine declared | — | Hela AZ 1 | — |
| Transmission | |||
| Top speed declared | 12.4–18.3 mph · 20.0–29.5 km/h | 12.3 mph · 19.8 km/h | differs |
| Clutch declared | Tornado duplex clutch (dual clutch DO 250/225 K) | single-plate dry clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 4.2 gpm · 16.0 L/min | 9.0 gpm · 34.0 L/min | +113% D 30 |
| Pressure declared | 1,740 psi · 120 bar | — | — |
| Rear PTO speeds declared | 553/1106 rpm | 572 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,968 lb · 1,800 kg | 3,671 lb · 1,665 kg | +8% Farmer 2 D |
| Maximum permissible mass declared | 5,732 lb · 2,600 kg | — | — |
| Wheelbase declared | 77.5 in · 1,968 mm | 74.8 in · 1,900 mm | — |
| Length declared | 128.5 in · 3,264 mm | 122.0 in · 3,100 mm | +5% Farmer 2 D |
| Width declared | 61.5 in · 1,562 mm | 61.0 in · 1,550 mm | — |
| Ground clearance declared | 15.9 in · 405 mm | 12.6 in · 320 mm | +27% Farmer 2 D |
| Turning radius, braked declared | 11.0 ft · 3.36 m | 9.8 ft · 3.00 m | +12% Farmer 2 D |
| Fuel tank declared | 42.3 qt · 40 L | 52.8 qt · 50 L | +25% D 30 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Farmer 2 D sources
- Source: Traktorenlexikon, “Fendt Farmer 2 D”
Hermann Lanz D 30 sources
- Source: Traktorenlexikon, “HELA D30”