9 material differences · fewer than 12
Tractor oneFendt Farmer 1051972–1973No measured PTO figureTractor twoInternational Harvester 4741973–1974No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Farmer 105 | 474 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 57.1 hp | 57.3 hp | — |
| Engine declared | MWM D 226-3 | INTERNATIONAL-HARVESTER D-206 | differs |
| Displacement declared | 3.12 L | 3.38 L | +9% 474 |
| Maximum torque declared | — | 156 lb·ft · 212 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | — | Pedal-operated dry LAYCOCK single-disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 8.9 gpm · 33.6 L/min | 11.4–12.6 gpm · 43.1–47.7 L/min | differs |
| Rear PTO speeds declared | 540/582 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,379 lb · 2,440 kg | 5,584 lb · 2,533 kg | — |
| Maximum permissible mass declared | 9,259 lb · 4,200 kg | — | — |
| Wheelbase declared | 83.4 in · 2,119 mm | 84.5 in · 2,146 mm | — |
| Length declared | 144.9 in · 3,681 mm | 135.0 in · 3,430 mm | +7% Farmer 105 |
| Width declared | 74.2 in · 1,884 mm | 64.2 in · 1,630 mm | +16% Farmer 105 |
| Ground clearance declared | 16.1 in · 410 mm | 16.0 in · 406 mm | — |
| Turning radius, braked declared | 12.0 ft · 3.65 m | 9.0 ft · 2.74 m | +33% Farmer 105 |
| Fuel tank declared | 68.7 qt · 65 L | 81.2 qt · 76.8 L | +18% 474 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Farmer 105 sources
- Source: Traktorenlexikon, “Fendt Farmer 105”
- Source: Traktorenlexikon, “Renault 551 R7451”
International Harvester 474 sources
- Source: Traktorenlexikon, “IHC 474”
- Source: Traktorenlexikon, “McCormick 624 (A)”
- Source: Traktorenlexikon, “IHC 474 (USA)”