Fendt 1Z or Hermann Lanz D 527?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 1Z has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the D 527 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Hermann Lanz D 527 suits loader and hydraulic implement work better on this data: 18% (215 kg / 474 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 1Z | D 527 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 18.3 kW (24.5 hp)Traktorenlexikon, “Fendt Farmer 1 Z” | 17.6 kW (23.6 hp)Traktorenlexikon, “HELA D527” | Not comparableNot comparable on power at the PTO shaft: the 1Z has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the D 527 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 1Z and the D 527. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 1Z and the D 527. |
| Which pumps more oil for implements? | 15.0 L/min (4.0 gpm)Traktorenlexikon, “Fendt Farmer 1 Z” | — | No figureNo call on hydraulic flow: no figure on record for the D 527. |
| Which lifts more on the three-point hitch? | 1,185 kg (2,612 lb)Traktorenlexikon, “Fendt Farmer 1 Z” | 1,400 kg (3,086 lb)Traktorenlexikon, “HELA D527” | AheadThe Hermann Lanz D 527 has 18% more lift (215 kg / 474 lb) than the Fendt 1Z (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 1,595 kg (3,516 lb)Traktorenlexikon, “Fendt Farmer 1 Z” | 1,680 kg (3,704 lb)Traktorenlexikon, “HELA D527” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 2,040 kg (4,497 lb)Traktorenlexikon, “Fendt Farmer 1 Z” | — | No figureNo call on maximum permissible mass: no figure on record for the D 527. |
| Which has the wider choice of gears? | 6Traktorenlexikon, “Fendt Farmer 1 Z” | 8Traktorenlexikon, “HELA D527” | AheadThe Hermann Lanz D 527 has 33% more forward gears (2 gears) than the Fendt 1Z (both forward gears, as stated by the source). |
| Which offers a creeper range? | YesTraktorenlexikon, “Fendt Farmer 1 Z” | YesTraktorenlexikon, “HELA D527” | EvenEven on a creeper range: every machine offers one. |
| Which is faster on the road? | 20 km/h (12.4 mph)Traktorenlexikon, “Fendt Farmer 1 Z” | 20 km/h (12.4 mph) to 25 km/h (15.5 mph)Traktorenlexikon, “HELA D527” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 585 rpmTraktorenlexikon, “Fendt Farmer 1 Z” | 570/1100 rpmTraktorenlexikon, “HELA D527” | No figureNo call on PTO speeds: no standard PTO speed stated for the 1Z and the D 527. |
| Which PTO runs independently of the ground drive? | dependent (stops with the clutch)Traktorenlexikon, “Fendt Farmer 1 Z” | independentTraktorenlexikon, “HELA D527” | AheadThe Hermann Lanz D 527 has an independent PTO; the Fendt 1Z’s is dependent (stops with the clutch). |
| Which drives on both axles? | 2WDTraktorenlexikon, “Fendt Farmer 1 Z” | 2WDTraktorenlexikon, “HELA D527” | EvenEven on drive: all two-wheel drive. |
| Which is newer, and what about parts? | 1963–1967 | 1968–1973 | Ahead (a fact, not an advantage)The Hermann Lanz D 527 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Hermann Lanz D 527 has 18% more lift (215 kg / 474 lb) than the Fendt 1Z (both lift at the hitch ends, as stated by the source).
- The Hermann Lanz D 527 has 33% more forward gears (2 gears) than the Fendt 1Z (both forward gears, as stated by the source).
- The Hermann Lanz D 527 has an independent PTO; the Fendt 1Z’s is dependent (stops with the clutch).
- The Hermann Lanz D 527 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on a creeper range: every machine offers one.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on drive: all two-wheel drive.
- Not comparable on power at the PTO shaft: the 1Z has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the D 527 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and PTO speeds.
← Every figure for both machines, side by side, with sources