10 material differences · fewer than 12
Tractor oneFendt F 345 GT1984–1996No measured PTO figureTractor twoFiat 440 (DT)1982No measured PTO figure
Which should you choose?
Read our verdict on the F 345 GT and the 440 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | F 345 GT | 440 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.1 hp | 44.4 hp | — |
| Engine declared | KHD-Unterflurmotor F3 L 912 H | FIAT-IVECO 8035.02 | differs |
| Displacement declared | 2.83 L | 2.59 L | +9% F 345 GT |
| Maximum torque declared | 128 lb·ft · 173 N·m | 114 lb·ft · 154 N·m | +12% F 345 GT |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 15.5 mph · 25 km/h | +60% F 345 GT |
| Clutch declared | — | dry FEREDO double clutch type 11/11" | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 7.1 gpm · 26.8 L/min | — |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 540/750/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,669 lb · 3,025 kg | 4,189 lb · 1,900 kg | +59% F 345 GT |
| Maximum permissible mass declared | 11,905 lb · 5,400 kg | — | — |
| Wheelbase declared | 118.1 in · 3,000 mm | 76.8 in · 1,950 mm | +54% F 345 GT |
| Length declared | 177.2 in · 4,500 mm | 126.8 in · 3,220 mm | +40% F 345 GT |
| Width declared | 68.1 in · 1,730 mm | 65.0 in · 1,650 mm | — |
| Ground clearance declared | 18.7 in · 475 mm | 13.8 in · 350 mm | +36% F 345 GT |
| Turning radius, braked declared | 12.5 ft · 3.80 m | 9.7 ft · 2.95 m | +29% F 345 GT |
| Fuel tank declared | — | 57.1 qt · 54.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt F 345 GT sources
- Source: Traktorenlexikon, “Fendt F 345 GT”
Fiat 440 (DT) sources
- Source: Traktorenlexikon, “Fiat 440/440 DT”
- Source: Traktorenlexikon, “Someca 440”