10 material differences · fewer than 12
Tractor oneFendt 924 Vario2006–2014No measured PTO figureTractor twoJohn Deere 8200 T1997–1998No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Tracks); they were not built in overlapping years (2006–2014; 1997–1998); the 8200 T is on tracks, not an alternative to an ordinary tractor. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 924 Vario | 8200 T | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 207 hp | 207.3 hp | — |
| Engine declared | Deutz TCD 2013 LO6 4V | John Deere-PowerTech 6.081 HRW-03 | differs |
| Displacement declared | 7.14 L | 8.13 L | +14% 8200 T |
| Maximum torque declared | 738 lb·ft · 1,000 N·m | 659 lb·ft · 893 N·m | +12% 924 Vario |
| Transmission | |||
| Top speed declared | 31.1–37.3 mph · 50–60 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | — | Pedal-operated, hydraulic-wet John Deere multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Hydraulic control declared | Load sensing | Load sensing | — |
| Pump flow declared | — | 31.1 gpm · 117.7 L/min | — |
| Pressure declared | — | 3,379 psi · 233 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 22,223 lb · 10,080 kg | 25,589 lb · 11,607 kg | +15% 8200 T |
| Maximum permissible mass declared | 33,069–39,683 lb · 15,000–18,000 kg | — | — |
| Wheelbase declared | 120.1 in · 3,050 mm | 89.0 in · 2,260 mm | +35% 924 Vario |
| Length declared | 222.6 in · 5,655 mm | 216.0 in · 5,487 mm | — |
| Width declared | 108.3 in · 2,750 mm | 102.0–109.3 in · 2,591–2,775 mm | differs |
| Ground clearance declared | 18.9 in · 480 mm | 14.2 in · 360 mm | +33% 924 Vario |
| Turning radius, braked declared | 19.9 ft · 6.08 m | — | — |
| Fuel tank declared | 697.4 qt · 660 L | 519.9 qt · 492.0 L | +34% 924 Vario |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt 924 Vario sources
- Source: Traktorenlexikon, “Fendt 924 Vario”
- Source: Traktorenlexikon, “Fendt 922 Vario”
- Source: OECD test report 2545, 2010
John Deere 8200 T sources
- Source: Traktorenlexikon, “John Deere 8200T”
- Source: OECD test report 1781, 1998