9 material differences · fewer than 12
Tractor oneFahr D 881956–1960No measured PTO figureTractor twoGüldner ADN1953–1959No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (29%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 88 | ADN | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | — | 15.7 hp | — |
| Engine declared | — | Güldner 2 DN or 2 DNS | — |
| Displacement declared | — | 1.31 L | — |
| Maximum torque declared | 30 lb·ft · 41 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 11.8 mph · 19 km/h | +32% D 88 |
| Clutch declared | Pedal operated dry Fichtel & Sachs single-plate clutch | Pedal operated dry Fichtel & Sachs single-plate clutch | — |
| Hydraulics & hitch | |||
| Pressure declared | 1,707 psi · 118 bar | 1,707 psi · 118 bar | — |
| Rear PTO speeds declared | 568 rpm | 530 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 1,907 lb · 865 kg | 2,458 lb · 1,115 kg | +29% ADN |
| Maximum permissible mass declared | 2,976 lb · 1,350 kg | 3,417 lb · 1,550 kg | +15% ADN |
| Wheelbase declared | 65.0 in · 1,650 mm | 63.0–70.5 in · 1,600–1,790 mm | differs |
| Length declared | 104.5 in · 2,655 mm | 103.7–111.2 in · 2,635–2,825 mm | differs |
| Width declared | 57.9 in · 1,470 mm | 59.6 in · 1,514 mm | — |
| Ground clearance declared | 13.8 in · 350 mm | 19.7 in · 500 mm | +43% ADN |
| Turning radius, braked declared | 8.6 ft · 2.63 m | 9.5 ft · 2.90 m | +10% ADN |
| Fuel tank declared | 20.1 qt · 19 L | 38.0 qt · 36 L | +89% ADN |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 88 sources
- Source: Traktorenlexikon, “Fahr D 88 E”
- Source: Traktorenlexikon, “Fahr D 88”
Güldner ADN sources
- Source: Traktorenlexikon, “Güldner ADN”