7 material differences · fewer than 12
Tractor oneFahr D 400 C1954–1957No measured PTO figureTractor twoHürlimann D-100 Allrad1966–1971No measured PTO figure
Which should you choose?
Read our verdict on the D 400 C and the D-100 Allrad → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 400 C | D-100 Allrad | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.1 hp | 44.1 hp | — |
| Engine declared | KHD F3L 514 | Hürlimann D-70 DS | differs |
| Displacement declared | 3.99 L | 2.65 L | +51% D 400 C |
| Maximum torque declared | 164 lb·ft · 223 N·m | 115 lb·ft · 156 N·m | +43% D 400 C |
| Transmission | |||
| Top speed declared | 12.9–18.6 mph · 20.8–30.0 km/h | 12.4 mph · 20 km/h | differs |
| Clutch declared | Pedal operated dry Fichtel & Sachs single-plate clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.9 gpm · 18.5 L/min | — | — |
| Pressure declared | 1,707 psi · 118 bar | — | — |
| Rear PTO speeds declared | 575 rpm | 540/1050 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,666 lb · 2,570 kg | 5,401 lb · 2,450 kg | — |
| Maximum permissible mass declared | 8,818 lb · 4,000 kg | — | — |
| Wheelbase declared | 82.7 in · 2,100 mm | — | — |
| Length declared | 134.3 in · 3,410 mm | 128.0 in · 3,250 mm | — |
| Width declared | 73.4 in · 1,865 mm | 68.5 in · 1,740 mm | +7% D 400 C |
| Ground clearance declared | 16.2 in · 412 mm | — | — |
| Turning radius, braked declared | 12.0 ft · 3.65 m | — | — |
| Fuel tank declared | 68.7 qt · 65 L | 42.3 qt · 40.0 L | +63% D 400 C |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 400 C sources
- Source: Traktorenlexikon, “Fahr D 400 C”
- Source: Traktorenlexikon, “Fahr D 45 L”
Hürlimann D-100 Allrad sources
- Source: Traktorenlexikon, “Hürlimann D 100 A”
- Source: Traktorenlexikon, “Hürlimann D 70 SSP”