11 material differences · fewer than 12
Tractor oneFahr D 30 UL1951No measured PTO figureTractor twoSteyr 301966–1976No measured PTO figure
Which should you choose?
Read our verdict on the D 30 UL and the 30 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D 30 UL | 30 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 29.6 hp | 29.6 hp | — |
| Engine declared | KHD F2L 514 | Steyr WD-210.40 | differs |
| Displacement declared | 2.66 L | 1.99 L | +34% D 30 UL |
| Maximum torque declared | 105 lb·ft · 142 N·m | 81 lb·ft · 110 N·m | +29% D 30 UL |
| Transmission | |||
| Top speed declared | 12.2 mph · 19.6 km/h | 17.4 mph · 28 km/h | +43% 30 |
| Clutch declared | Pedal operated dry Fichtel & Sachs single plate clutch | Pedal-operated dry Fichtel & Sachs single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 5.6 gpm · 21.2 L/min | — |
| Pressure declared | 3,129 psi · 216 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,696 lb · 2,130 kg | 3,882 lb · 1,761 kg | +21% D 30 UL |
| Maximum permissible mass declared | — | 5,512 lb · 2,500 kg | — |
| Wheelbase declared | 86.4 in · 2,195 mm | 72.8 in · 1,850 mm | +19% D 30 UL |
| Length declared | 117.7 in · 2,990 mm | 128.0 in · 3,250 mm | +9% 30 |
| Width declared | 59.6 in · 1,515 mm | 63.5–69.7 in · 1,614–1,770 mm | differs |
| Ground clearance declared | 11.8 in · 300 mm | 16.9 in · 430 mm | +43% 30 |
| Turning radius, braked declared | — | 8.5 ft · 2.60 m | — |
| Fuel tank declared | 31.7 qt · 30 L | 65.5 qt · 62.0 L | +107% 30 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 30 UL sources
- Source: Traktorenlexikon, “Fahr D 30 UL”
- Source: Traktorenlexikon, “Fahr D 270”
Steyr 30 sources
- Source: Traktorenlexikon, “Steyr Plus 30”