8 material differences · fewer than 12
Tractor oneFahr D 22 P1951–1953No measured PTO figureTractor twoInternational Harvester D-324 Standard1958–1962No measured PTO figure
Which should you choose?
Read our verdict on the D 22 P and the D-324 Standard → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D 22 P | D-324 Standard | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 21.6 hp | 23.7 hp | +10% D-324 Standard |
| Engine declared | Güldner 2 DA | INTERNATIONAL-HARVESTER DD-111 | differs |
| Displacement declared | 1.63 L | 1.83 L | +12% D-324 Standard |
| Maximum torque declared | 71 lb·ft · 96 N·m | 73 lb·ft · 99 N·m | — |
| Transmission | |||
| Top speed declared | 11.3 mph · 18.2 km/h | 11.8 mph · 19 km/h | — |
| Clutch declared | — | Pedal operated dry single plate clutch | — |
| Hydraulics & hitch | |||
| Pressure declared | 3,129 psi · 216 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,976 lb · 1,350 kg | 3,386 lb · 1,536 kg | +14% D-324 Standard |
| Maximum permissible mass declared | 4,189 lb · 1,900 kg | — | — |
| Wheelbase declared | 64.6 in · 1,640 mm | 70.0 in · 1,779 mm | +8% D-324 Standard |
| Length declared | 101.2 in · 2,570 mm | 108.3 in · 2,750 mm | +7% D-324 Standard |
| Width declared | 61.5 in · 1,562 mm | 64.6 in · 1,640 mm | — |
| Ground clearance declared | 16.1 in · 410 mm | 15.1 in · 383 mm | +7% D 22 P |
| Turning radius, braked declared | 7.6 ft · 2.33 m | 9.2 ft · 2.80 m | +20% D-324 Standard |
| Fuel tank declared | 33.8 qt · 32 L | 31.7 qt · 30.0 L | +7% D 22 P |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 22 P sources
- Source: Traktorenlexikon, “Fahr D 22 P”
- Source: Traktorenlexikon, “Güldner AF 20”
International Harvester D-324 Standard sources
- Source: Traktorenlexikon, “McCormick D-324 Standard”
- Source: Traktorenlexikon, “McCormick D-324 Farmall”