10 material differences · fewer than 12
Tractor oneFahr D 17 H1951–1953No measured PTO figureTractor twoFahr D 881956–1960No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (56%); they were not built in overlapping years (1951–1953; 1956–1960). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D 17 H | D 88 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 16.8 hp | — | — |
| Engine declared | Güldner 2 D 15 | — | — |
| Displacement declared | 1.30 L | — | — |
| Maximum torque declared | 54 lb·ft · 74 N·m | 30 lb·ft · 41 N·m | +80% D 17 H |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 15.5 mph · 25 km/h | +25% D 88 |
| Clutch declared | — | Pedal operated dry Fichtel & Sachs single-plate clutch | — |
| Hydraulics & hitch | |||
| Pressure declared | 3,129 psi · 216 bar | 1,707 psi · 118 bar | +83% D 17 H |
| Rear PTO speeds declared | 540 rpm | 568 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,976 lb · 1,350 kg | 1,907 lb · 865 kg | +56% D 17 H |
| Maximum permissible mass declared | 4,409 lb · 2,000 kg | 2,976 lb · 1,350 kg | +48% D 17 H |
| Wheelbase declared | 64.4 in · 1,635 mm | 65.0 in · 1,650 mm | — |
| Length declared | 103.1 in · 2,620 mm | 104.5 in · 2,655 mm | — |
| Width declared | 61.5 in · 1,562 mm | 57.9 in · 1,470 mm | +6% D 17 H |
| Ground clearance declared | 19.3 in · 490 mm | 13.8 in · 350 mm | +40% D 17 H |
| Turning radius, braked declared | 7.6 ft · 2.33 m | 8.6 ft · 2.63 m | +13% D 88 |
| Fuel tank declared | 26.4 qt · 25 L | 20.1 qt · 19 L | +32% D 17 H |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 17 H sources
- Source: Traktorenlexikon, “Fahr D 17 H”
- Source: Traktorenlexikon, “Fahr D 17”
Fahr D 88 sources
- Source: Traktorenlexikon, “Fahr D 88 E”
- Source: Traktorenlexikon, “Fahr D 88”