4 material differences · fewer than 12
Tractor oneFahr D 12 H1952–1953No measured PTO figureTractor twoFahr D 12 NH1953–1954No measured PTO figure
Which should you choose?
Read our verdict on the D 12 H and the D 12 NH → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
4 material differences · 12 fields identical or within 5%, which is not counted as material
| Field | D 12 H | D 12 NH | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 11.8 hp | 11.8 hp | — |
| Engine declared | Güldner 1 DA | Güldner 1 DA | — |
| Displacement declared | 0.82 L | 0.82 L | — |
| Maximum torque declared | 33 lb·ft · 45 N·m | 33 lb·ft · 45 N·m | — |
| Transmission | |||
| Top speed declared | 12.3 mph · 19.8 km/h | 12.3 mph · 19.8 km/h | — |
| Clutch declared | Pedal operated dry Fichtel & Sachs single disc clutch | dry single disc clutch | differs |
| Hydraulics & hitch | |||
| Pressure declared | 3,129 psi · 216 bar | 3,129 psi · 216 bar | — |
| Rear PTO speeds declared | 600 rpm | 588 | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,535 lb · 1,150 kg | 2,601 lb · 1,180 kg | — |
| Maximum permissible mass declared | 3,638 lb · 1,650 kg | 3,836 lb · 1,740 kg | +5% D 12 NH |
| Wheelbase declared | 60.6 in · 1,540 mm | 60.4 in · 1,535 mm | — |
| Length declared | 97.2 in · 2,470 mm | 97.2 in · 2,470 mm | — |
| Width declared | 61.5 in · 1,562 mm | 58.7 in · 1,492 mm | — |
| Ground clearance declared | 16.1 in · 410 mm | 19.4 in · 493 mm | +20% D 12 NH |
| Turning radius, braked declared | 6.9 ft · 2.10 m | 6.7 ft · 2.05 m | — |
| Fuel tank declared | 26.4 qt · 25 L | 26.4 qt · 25 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 12 H sources
- Source: Traktorenlexikon, “Fahr D 12 H”
- Source: Traktorenlexikon, “Fahr D 12”
Fahr D 12 NH sources
- Source: Traktorenlexikon, “Fahr D 12 NH”
- Source: Traktorenlexikon, “Fahr D 12”