3 material differences · fewer than 12
Tractor oneEicher Mammut 33541974–1978No measured PTO figureTractor twoVALMET 6021978–1982No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
3 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | Mammut 3354 | 602 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 54.0 hp | 57.3 hp | +6% 602 |
| Engine declared | Perkins AD 4.203 | VALMET 311 C | differs |
| Displacement declared | 3.34 L | 3.30 L | — |
| Maximum torque declared | 162 lb·ft · 220 N·m | 155 lb·ft · 210 N·m | — |
| Transmission | |||
| Top speed declared | 14.9 mph · 24 km/h | 18.6 mph · 30 km/h | +25% 602 |
| Clutch declared | — | Dry BORG & BECK double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 5.0 gpm · 19.0 L/min | 8.2 gpm · 30.9 L/min | +63% 602 |
| Pressure declared | 2,987 psi · 206 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,842 lb · 2,650 kg | 6,129 lb · 2,780 kg | — |
| Wheelbase declared | 84.4 in · 2,145 mm | 83.1 in · 2,112 mm | — |
| Length declared | 132.7 in · 3,370 mm | 137.3 in · 3,487 mm | — |
| Width declared | 72.8 in · 1,850 mm | 69.6 in · 1,769 mm | — |
| Ground clearance declared | — | 18.9 in · 480 mm | — |
| Turning radius, braked declared | — | 9.8 ft · 3.00 m | — |
| Fuel tank declared | 71.9 qt · 68 L | 68.7 qt · 65.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Eicher Mammut 3354 sources
- Source: Traktorenlexikon, “Eicher 3354 Mammut 74 A”
VALMET 602 sources
- Source: Traktorenlexikon, “Valmet 602”