10 material differences · fewer than 12
Tractor oneEicher 31331977–1982No measured PTO figureTractor twoInternational Harvester 14661971–1976No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1977–1982; 1971–1976). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 3133 | 1466 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 131 hp | 133.2 hp | — |
| Engine declared | Eicher EDK 6-5 | INTERNATIONAL HARVESTER DT-436 | differs |
| Displacement declared | 5.89 L | 7.14 L | +21% 1466 |
| Maximum torque declared | 332 lb·ft · 450 N·m | — | — |
| Transmission | |||
| Top speed declared | 19.6 mph · 31.5 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | F&S single dry clutch for driving clutch | Pedal operated ceramic clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 11.1 gpm · 42.0 L/min | 12.0 gpm · 45.5 L/min | +8% 1466 |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,236 lb · 5,550 kg | 13,479 lb · 6,114 kg | +10% 1466 |
| Maximum permissible mass declared | 16,535 lb · 7,500 kg | — | — |
| Wheelbase declared | 107.5 in · 2,730 mm | 104.8 in · 2,662 mm | — |
| Length declared | 181.5 in · 4,610 mm | 168.0 in · 4,267 mm | +8% 3133 |
| Width declared | 91.7 in · 2,330 mm | 98.0 in · 2,489 mm | +7% 1466 |
| Ground clearance declared | 16.9 in · 430 mm | 16.0 in · 406 mm | +6% 3133 |
| Turning radius, braked declared | 17.7 ft · 5.40 m | 11.7 ft · 3.56 m | +52% 3133 |
| Fuel tank declared | — | 168.0 qt · 159.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Eicher 3133 sources
- Source: Traktorenlexikon, “Eicher 3133”
International Harvester 1466 sources
- Source: Traktorenlexikon, “IHC 1466”
- Source: Traktorenlexikon, “Farmall Farmall 1466”