5 material differences · fewer than 12

F)1983–1987No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (44%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

5 material differences · 4 fields identical or within 5%, which is not counted as material

Eicher 3072 and Landini 7830 (DT) TL-20 N/F (TL-20 DT/F), field by field
Field	3072	7830 (DT) TL-20 N/F (TL-20 DT/F)	Gap
Engine
Engine power, claimed claimed	71 hp	71 hp	—
Engine declared	Eicher EDL 4 - 4 Turbo	Perkins A 4.236	differs
Displacement declared	3.93 L	3.87 L	—
Maximum torque declared	—	202 lb·ft · 274 N·m	—
Transmission
Top speed declared	18.6–24.9 mph · 30–40 km/h	18.6 mph · 30 km/h	differs
Hydraulics & hitch
Pump flow declared	—	10.2 gpm · 38.7 L/min	—
Rear PTO speeds declared	540 rpm / 1000 rpm	540/1000 rpm	differs
Weight & dimensions
Unladen weight declared	8,631 lb · 3,915 kg	5,986 lb · 2,715 kg	+44% 3072
Wheelbase declared	101.0 in · 2,565 mm	87.0 in · 2,210 mm	+16% 3072
Length declared	151.2 in · 3,840 mm	147.6 in · 3,750 mm	—
Width declared	82.7 in · 2,100 mm	78.7 in · 1,999 mm	—
Ground clearance declared	—	21.1 in · 535 mm	—
Turning radius, braked declared	—	12.8 ft · 3.89 m	—
Fuel tank declared	—	63.9 qt · 60.5 L	—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Eicher 3072 sources

Source

Source: Traktorenlexikon, “Eicher 3072”

Landini 7830 (DT) TL-20 N/F (TL-20 DT/F) sources