10 material differences · fewer than 12
Tractor oneEicher 3048 AS1982–1990No measured PTO figureTractor twoURSUS C-360 3P1981–1993No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (57%); the drive differs (4WD; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 3048 AS | C-360 3P | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47 hp | 46.8 hp | — |
| Engine declared | Eicher EDL 3 - 7 | PERKINS AD 3.152 UR | differs |
| Displacement declared | 2.93 L | 2.50 L | +17% 3048 AS |
| Maximum torque declared | — | 122 lb·ft · 165 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–24.9 mph · 25–40 km/h | 15.5 mph · 25 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.9 gpm · 26 L/min | 5.7 gpm · 21.5 L/min | +21% 3048 AS |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540 rpm / 750 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,099 lb · 3,220 kg | 4,533 lb · 2,056 kg | +57% 3048 AS |
| Maximum permissible mass declared | 7,716 lb · 3,500 kg | — | — |
| Wheelbase declared | 92.5 in · 2,350 mm | 85.5 in · 2,172 mm | +8% 3048 AS |
| Length declared | 139.2 in · 3,535 mm | 142.1 in · 3,610 mm | — |
| Width declared | 78.5 in · 1,995 mm | 70.9 in · 1,800 mm | +11% 3048 AS |
| Ground clearance declared | — | 17.3 in · 440 mm | — |
| Turning radius, braked declared | 12.5 ft · 3.80 m | 11.1 ft · 3.37 m | +13% 3048 AS |
| Fuel tank declared | 103.6 qt · 98 L | 71.9 qt · 68.0 L | +44% 3048 AS |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Eicher 3048 AS sources
- Source: Traktorenlexikon, “Eicher 3048 A”
- Source: Traktorenlexikon, “Eicher 645 K”
URSUS C-360 3P sources
- Source: Traktorenlexikon, “Ursus C-360-3P”