5 material differences · fewer than 12
Tractor oneDoppstadt Trac 1601999–2001No measured PTO figureTractor twoMassey Ferguson MF 8140 A1995–1999No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Trac 160 | MF 8140 A | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 158 hp | 158.0 hp | — |
| Engine declared | — | Valmet 620 DS | — |
| Displacement declared | — | 6.60 L | — |
| Maximum torque declared | — | 470 lb·ft · 637 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Pedal-operated dry Valeo double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | — | 14.1 gpm · 53.3 L/min | — |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 15,829 lb · 7,180 kg | 13,481 lb · 6,115 kg | +17% Trac 160 |
| Maximum permissible mass declared | — | 25,353 lb · 11,500 kg | — |
| Wheelbase declared | 110.2 in · 2,800 mm | 115.7 in · 2,940 mm | — |
| Length declared | 188.6 in · 4,790 mm | 198.3 in · 5,038 mm | — |
| Width declared | 98.4 in · 2,500 mm | 83.5–103.7 in · 2,120–2,633 mm | differs |
| Ground clearance declared | 27.2 in · 690 mm | 18.2 in · 463 mm | +49% Trac 160 |
| Fuel tank declared | — | 285.3 qt · 270.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Doppstadt Trac 160 sources
- Source: Traktorenlexikon, “Doppstadt Trac 160”
Massey Ferguson MF 8140 A sources
- Source: Traktorenlexikon, “Massey Ferguson MF 8140”
- Source: Traktorenlexikon, “Massey Ferguson MF 3670”