4 material differences · fewer than 12
Tractor oneDoppstadt Trac 1601999–2001No measured PTO figureTractor twoFiat M 1601996–1999No measured PTO figure
Which should you choose?
Read our verdict on the Trac 160 and the M 160 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
4 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Trac 160 | M 160 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 158 hp | 158.0 hp | — |
| Engine declared | — | New Holland 675 T-WM | — |
| Displacement declared | — | 7.48 L | — |
| Maximum torque declared | — | 481 lb·ft · 652 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Electro-hydraulically operated running in oil New Holland multi-disc driving clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | — | 26.0 gpm · 98.4 L/min | — |
| Pressure declared | — | 2,408–2,582 psi · 166–178 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 15,829 lb · 7,180 kg | 13,404 lb · 6,080 kg | +18% Trac 160 |
| Maximum permissible mass declared | — | 20,944 lb · 9,500 kg | — |
| Wheelbase declared | 110.2 in · 2,800 mm | 107.2 in · 2,723 mm | — |
| Length declared | 188.6 in · 4,790 mm | 183.3 in · 4,655 mm | — |
| Width declared | 98.4 in · 2,500 mm | 84.1–109.1 in · 2,135–2,771 mm | differs |
| Ground clearance declared | 27.2 in · 690 mm | 14.5 in · 369 mm | +87% Trac 160 |
| Fuel tank declared | — | 232.5 qt · 220.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Doppstadt Trac 160 sources
- Source: Traktorenlexikon, “Doppstadt Trac 160”
Fiat M 160 sources
- Source: Traktorenlexikon, “Fiatagri M160”
- Source: Traktorenlexikon, “New Holland 8560”