8 material differences · fewer than 12
Tractor oneDexheimer Allrad 345 N1976–1985No measured PTO figureTractor twoLandini 5830 (DT) TL-22 N/G (TL-DT/L)1983–1987No measured PTO figure
Which should you choose?
Read our verdict on the Allrad 345 N and the 5830 (DT) TL-22 N/G (TL-DT/L) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Allrad 345 N | 5830 (DT) TL-22 N/G (TL-DT/L) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 50 hp | 49.3 hp | — |
| Engine declared | — | Perkins AD 3.152 S | — |
| Displacement declared | — | 2.50 L | — |
| Maximum torque declared | — | 133 lb·ft · 181 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 5830 (DT) TL-22 N/G (TL-DT/L) |
| Clutch declared | — | Dry, air-cooled OMG double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.8 gpm · 41 L/min | 9.5 gpm · 36.1 L/min | +14% Allrad 345 N |
| Rear PTO speeds declared | — | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,583 lb · 1,625 kg | 4,674 lb · 2,120 kg | +30% 5830 (DT) TL-22 N/G (TL-DT/L) |
| Wheelbase declared | 81.1 in · 2,060 mm | 81.9 in · 2,080 mm | — |
| Length declared | 114.2 in · 2,900 mm | 140.7 in · 3,575 mm | +23% 5830 (DT) TL-22 N/G (TL-DT/L) |
| Width declared | 39.8 in · 1,010 mm | 69.1 in · 1,755 mm | +74% 5830 (DT) TL-22 N/G (TL-DT/L) |
| Ground clearance declared | 10.6 in · 270 mm | 17.1 in · 435 mm | +61% 5830 (DT) TL-22 N/G (TL-DT/L) |
| Turning radius, braked declared | 6.9 ft · 2.10 m | 12.4 ft · 3.79 m | +80% 5830 (DT) TL-22 N/G (TL-DT/L) |
| Fuel tank declared | 52.8 qt · 50 L | 63.9 qt · 60.5 L | +21% 5830 (DT) TL-22 N/G (TL-DT/L) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Dexheimer Allrad 345 N sources
- Source: Traktorenlexikon, “Dexheimer ALLRAD 345 N”
Landini 5830 (DT) TL-22 N/G (TL-DT/L) sources
- Source: Traktorenlexikon, “Landini 5830 (DT)”
- Source: Traktorenlexikon, “Massey Ferguson MF 255”