Deutz (KHD) Intrac 2002 vs John Deere-LANZ 710

11 material differences · fewer than 12

Tractor one

1972–1974

No measured PTO figure

Tractor two

1965–1967

No measured PTO figure

Which should you choose?

Read our verdict on the Intrac 2002 and the 710 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

11 material differences · 5 fields identical or within 5%, which is not counted as material

Deutz (KHD) Intrac 2002 and John Deere-LANZ 710, field by field
Field	Intrac 2002	710	Gap
Engine
Engine power, claimed claimed	50.0 hp	49.3 hp	—
Engine declared	KHD F3L 912 H	John Deere 202 D 23 L	differs
Displacement declared	2.83 L	3.32 L	+17% 710
Maximum torque declared	135 lb·ft · 182 N·m	132 lb·ft · 178 N·m	—
Transmission
Top speed declared	15.5 mph · 25 km/h	12.4–15.5 mph · 20–25 km/h	differs
Clutch declared	Independent dry double clutch	—	—
Hydraulics & hitch
Pump flow declared	—	4.1 gpm · 15.6 L/min	—
Pressure declared	2,538 psi · 175 bar	2,162 psi · 149 bar	+17% Intrac 2002
Three-point lift at ends declared	4,630 lb · 2,100 kg	3,968 lb · 1,800 kg	+17% Intrac 2002
Rear PTO speeds declared	540/1000 rpm	540/1000 rpm	—
Weight & dimensions
Unladen weight declared	5,908 lb · 2,680 kg	4,925 lb · 2,234 kg	+20% Intrac 2002
Maximum permissible mass declared	—	7,716 lb · 3,500 kg	—
Wheelbase declared	84.6 in · 2,150 mm	86.6 in · 2,200 mm	—
Length declared	137.8 in · 3,500 mm	139.0 in · 3,530 mm	—
Width declared	74.4 in · 1,890 mm	70.5 in · 1,790 mm	+6% Intrac 2002
Height declared	98.4 in · 2,500 mm	68.9 in · 1,750 mm	+43% Intrac 2002
Ground clearance declared	17.9 in · 455 mm	19.7 in · 500 mm	+10% 710
Turning radius, braked declared	12.1 ft · 3.70 m	10.2 ft · 3.10 m	+19% Intrac 2002
Fuel tank declared	91.9 qt · 87 L	74.0 qt · 70.0 L	+24% Intrac 2002

Source

Source