Deutz (KHD) Intrac 2002 or International Harvester 454?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the Intrac 2002 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 454 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Deutz Intrac 2002 suits heavy draft work (ploughing, cultivating) better on this data: 25% (539 kg / 1,188 lb) heavier and four-wheel drive.
- The International Harvester 454 suits road haulage better on this data: 28% (7.0 km/h / 4.3 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | Intrac 2002 | 454 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 37.3 kW (50.0 hp)Traktorenlexikon, “Deutz INTRAC 2002” | 36.8 kW (49.3 hp)Traktorenlexikon, “IHC 454 (USA)” | Not comparableNot comparable on power at the PTO shaft: the Intrac 2002 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 454 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the Intrac 2002 and the 454. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the Intrac 2002 and the 454. |
| Which pumps more oil for implements? | — | 43.1 L/min (11.4 gpm) to 47.7 L/min (12.6 gpm)Traktorenlexikon, “IHC 454 (USA)” | No figureNo call on hydraulic flow: no figure on record for the Intrac 2002. |
| Which lifts more on the three-point hitch? | 2,100 kg (4,630 lb)Traktorenlexikon, “Deutz INTRAC 2002” | — | No figureNo call on three-point lift: no figure on record for the 454. |
| Which is heavier, for traction? | 2,680 kg (5,908 lb)Traktorenlexikon, “Deutz INTRAC 2002” | 2,141 kg (4,720 lb)Traktorenlexikon, “IHC 454 (USA)” | Ahead (a fact, not an advantage)The Deutz Intrac 2002 is 25% heavier (539 kg / 1,188 lb) than the International Harvester 454 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the Intrac 2002 and the 454. |
| Which has the wider choice of gears? | — | 8Traktorenlexikon, “IHC 454 (USA)” | No figureNo call on forward gears: no figure on record for the Intrac 2002. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the Intrac 2002 and the 454. |
| Which is faster on the road? | 25 km/h (15.5 mph)Traktorenlexikon, “Deutz INTRAC 2002” | 32 km/h (19.9 mph)Traktorenlexikon, “IHC 454 (USA)” | AheadThe International Harvester 454 has 28% more top speed (7.0 km/h / 4.3 mph) than the Deutz Intrac 2002 (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Deutz INTRAC 2002” | 540/1000 rpmTraktorenlexikon, “IHC 454 (USA)” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz INTRAC 2002” | independentTraktorenlexikon, “IHC 454 (USA)” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 2WD / 4WDTraktorenlexikon, “Deutz INTRAC 2002” | 2WDTraktorenlexikon, “IHC 454 (USA)” | AheadThe Deutz Intrac 2002 is available with four-wheel drive; the International Harvester 454 is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1972–1974 | 1970–1973 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz Intrac 2002 is 25% heavier (539 kg / 1,188 lb) than the International Harvester 454 (both unladen weight, as stated by the source).
- The International Harvester 454 has 28% more top speed (7.0 km/h / 4.3 mph) than the Deutz Intrac 2002 (both top speed forward, as stated by the source).
- The Deutz Intrac 2002 is available with four-wheel drive; the International Harvester 454 is two-wheel drive (as stated by the sources).
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the Intrac 2002 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 454 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass, forward gears and a creeper range.
← Every figure for both machines, side by side, with sources