9 material differences · fewer than 12
Tractor oneDeutz-Fahr IN-trac 6.051987No measured PTO figureTractor twoURSUS 11341990–2009No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (26%); they were not built in overlapping years (1987–1987; 1990–2009). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | IN-trac 6.05 | 1134 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 97 hp | 97 hp | — |
| Engine declared | Deutz F6L 912 | Z.T.S.-MARTIN Z-8402.12 | differs |
| Displacement declared | 5.66 L | 4.56 L | +24% IN-trac 6.05 |
| Maximum torque declared | — | 249 lb·ft · 337 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% IN-trac 6.05 |
| Clutch declared | — | Pedal-operated hydraulic dry single-disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 14.8 gpm · 56.0 L/min | 12.0 gpm · 45.3 L/min | +24% IN-trac 6.05 |
| Pressure declared | — | 2,828 psi · 195 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,803 lb · 4,900 kg | 13,558 lb · 6,150 kg | +26% 1134 |
| Maximum permissible mass declared | 19,180 lb · 8,700 kg | 16,314 lb · 7,400 kg | +18% IN-trac 6.05 |
| Wheelbase declared | 106.4 in · 2,703 mm | 94.3 in · 2,396 mm | +13% IN-trac 6.05 |
| Length declared | 196.9 in · 5,000 mm | 170.9 in · 4,340 mm | +15% IN-trac 6.05 |
| Width declared | 90.6 in · 2,300 mm | 82.1–92.9 in · 2,085–2,360 mm | differs |
| Ground clearance declared | — | 13.0 in · 330 mm | — |
| Turning radius, braked declared | — | 15.7 ft · 4.78 m | — |
| Fuel tank declared | — | 137.4 qt · 130.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr IN-trac 6.05 sources
- Source: Traktorenlexikon, “Deutz-Fahr IN-trac 6.05”
URSUS 1134 sources
- Source: Wikipedia (pl): Ursus 1134 (open data)
- Source: Traktorenlexikon, “Ursus 1134”