7 material differences · fewer than 12
Tractor oneDeutz-Fahr IN-trac 6.051987No measured PTO figureTractor twoSAME Laser 100 (DT)1986–1991No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | IN-trac 6.05 | Laser 100 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 97 hp | 96.7 hp | — |
| Engine declared | Deutz F6L 912 | SAME 1055-P | differs |
| Displacement declared | 5.66 L | 5.20 L | +9% IN-trac 6.05 |
| Maximum torque declared | — | 242 lb·ft · 328 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% IN-trac 6.05 |
| Clutch declared | — | Pedal-operated dry SAME single-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 14.8 gpm · 56.0 L/min | 17.4 gpm · 66.0 L/min | +18% Laser 100 (DT) |
| Pressure declared | — | 1,740 psi · 120 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,803 lb · 4,900 kg | 8,686 lb · 3,940 kg | +24% IN-trac 6.05 |
| Maximum permissible mass declared | 19,180 lb · 8,700 kg | — | — |
| Wheelbase declared | 106.4 in · 2,703 mm | 103.0 in · 2,617 mm | — |
| Length declared | 196.9 in · 5,000 mm | 153.0 in · 3,885 mm | +29% IN-trac 6.05 |
| Width declared | 90.6 in · 2,300 mm | 77.0–101.1 in · 1,957–2,567 mm | differs |
| Ground clearance declared | — | 20.7 in · 527 mm | — |
| Turning radius, braked declared | — | 11.0 ft · 3.35 m | — |
| Fuel tank declared | — | 126.8 qt · 120.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr IN-trac 6.05 sources
- Source: Traktorenlexikon, “Deutz-Fahr IN-trac 6.05”
SAME Laser 100 (DT) sources
- Source: Traktorenlexikon, “SAME Laser 100”
- Source: Traktorenlexikon, “Lamborghini 955 DT”