6 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 861982–1983No measured PTO figureTractor twoWHITE 60851992–1997No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1982–1983; 1992–1997). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | DX 86 | 6085 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 80 hp | 79.9 hp | — |
| Engine declared | KHD BF4L 913 T | SLH 1.000.4 WT | differs |
| Displacement declared | 4.09 L | 4.00 L | — |
| Maximum torque declared | 211 lb·ft · 286 N·m | 225 lb·ft · 305 N·m | +7% 6085 |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | — | Pedal operated dry single disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 10.5 gpm · 39.6 L/min | — | — |
| Pressure declared | — | 1,740 psi · 120 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,091 lb · 3,670 kg | 6,724 lb · 3,050 kg | +20% DX 86 |
| Wheelbase declared | 91.7 in · 2,330 mm | 94.9 in · 2,410 mm | — |
| Length declared | 159.1 in · 4,040 mm | 158.7 in · 4,030 mm | — |
| Width declared | 90.6 in · 2,300 mm | 81.1 in · 2,060 mm | +12% DX 86 |
| Ground clearance declared | 20.9 in · 530 mm | 20.5 in · 520 mm | — |
| Turning radius, braked declared | — | 9.6 ft · 2.94 m | — |
| Fuel tank declared | 126.8 qt · 120 L | 105.7 qt · 100.0 L | +20% DX 86 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 86 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 86”
- Source: Traktorenlexikon, “Deutz-Fahr DX 4.50”
WHITE 6085 sources
- Source: Traktorenlexikon, “AGCO-White 6085”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 87”
- Source: Traktorenlexikon, “White 6085”