Deutz-Fahr DX 6.10 vs SAME Buffalo DT

11 material differences · fewer than 12

Tractor one

1983–1990

No measured PTO figure

Tractor two

1968–1974

No measured PTO figure

Which should you choose?

Read our verdict on the DX 6.10 and the Buffalo DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

11 material differences · 3 fields identical or within 5%, which is not counted as material

Deutz-Fahr DX 6.10 and SAME Buffalo DT, field by field
Field	DX 6.10	Buffalo DT	Gap
Engine
Engine power, claimed claimed	98.2 hp	103.5 hp	+5% Buffalo DT
Engine declared	KHD F6L 912.74	SAME DA 1006-V	differs
Displacement declared	5.65 L	5.66 L	—
Maximum torque declared	263 lb·ft · 356 N·m	280 lb·ft · 380 N·m	+7% Buffalo DT
Transmission
Top speed declared	18.6–24.9 mph · 30–40 km/h	15.5 mph · 25 km/h	differs
Clutch declared	—	Pedal-operated dry SAME single-disc clutch	—
Hydraulics & hitch
Pump flow declared	14.7 gpm · 55.6 L/min	7.9 gpm · 30.0 L/min	+85% DX 6.10
Three-point lift at ends declared	11,464 lb · 5,200 kg	6,614 lb · 3,000 kg	+73% DX 6.10
Rear PTO speeds declared	540/1000 rpm	540/1000 rpm	—
Weight & dimensions
Unladen weight declared	10,472 lb · 4,750 kg	9,524 lb · 4,320 kg	+10% DX 6.10
Maximum permissible mass declared	14,991 lb · 6,800 kg	—	—
Wheelbase declared	106.4 in · 2,703 mm	100.8 in · 2,560 mm	+6% DX 6.10
Length declared	179.1 in · 4,550 mm	157.5 in · 4,000 mm	+14% DX 6.10
Width declared	90.7 in · 2,304 mm	85.8 in · 2,180 mm	+6% DX 6.10
Height declared	111.0 in · 2,820 mm	75.6 in · 1,920 mm	+47% DX 6.10
Ground clearance declared	20.1 in · 510 mm	17.3 in · 440 mm	+16% DX 6.10
Turning radius, braked declared	15.9 ft · 4.86 m	16.4 ft · 5.00 m	—
Fuel tank declared	126.8 qt · 120 L	—	—

Source

Source