8 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 6.101983–1990No measured PTO figureTractor twoInternational Harvester 1055 XL1981–1982No measured PTO figure
Which should you choose?
Read our verdict on the DX 6.10 and the 1055 XL → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | DX 6.10 | 1055 XL | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 98.2 hp | 98.6 hp | — |
| Engine declared | KHD F6L 912.74 | IH D-358 | differs |
| Displacement declared | 5.65 L | 5.87 L | — |
| Maximum torque declared | 263 lb·ft · 356 N·m | 279 lb·ft · 378 N·m | +6% 1055 XL |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 14.7 gpm · 55.6 L/min | 9.5 gpm · 36.0 L/min | +54% DX 6.10 |
| Pressure declared | — | 2,466 psi · 170 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,472 lb · 4,750 kg | 9,634 lb · 4,370 kg | +9% DX 6.10 |
| Maximum permissible mass declared | 14,991 lb · 6,800 kg | — | — |
| Wheelbase declared | 106.4 in · 2,703 mm | 103.5 in · 2,630 mm | — |
| Length declared | 179.1 in · 4,550 mm | 165.1 in · 4,194 mm | +8% DX 6.10 |
| Width declared | 90.7 in · 2,304 mm | 90.8 in · 2,306 mm | — |
| Ground clearance declared | 20.1 in · 510 mm | 20.2 in · 512 mm | — |
| Turning radius, braked declared | 15.9 ft · 4.86 m | 14.4 ft · 4.40 m | +10% DX 6.10 |
| Fuel tank declared | 126.8 qt · 120 L | 147.9 qt · 140 L | +17% 1055 XL |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 6.10 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 6.10”
International Harvester 1055 XL sources
- Source: Traktorenlexikon, “IHC 1055 XL”