Deutz-Fahr DX 3.80 AS or New Holland TL 80 (A)?
Which should you choose?
On performance, every comparable figure that differs favours the New Holland TL 80 (A): hydraulic flow, three-point lift and maximum permissible mass.
- The New Holland TL 80 (A) suits loader and hydraulic implement work better on this data: 50% (20.0 L/min / 5.3 gpm) more hydraulic flow and 40% (950 kg / 2,094 lb) more three-point lift.
- The New Holland TL 80 (A) suits road haulage better on this data: 30% (1,200 kg / 2,646 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | DX 3.80 AS | TL 80 (A) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 49.4 kW (66.2 hp)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 49.2 kW (66.0 hp)Traktorenlexikon, “New Holland TL80” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the DX 3.80 AS and the TL 80 (A). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the DX 3.80 AS and the TL 80 (A). |
| Which pumps more oil for implements? | 40.0 L/min (10.6 gpm)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 60.0 L/min (15.9 gpm)Traktorenlexikon, “New Holland TL80” | AheadThe New Holland TL 80 (A) has 50% more hydraulic flow (20.0 L/min / 5.3 gpm) than the Deutz-Fahr DX 3.80 AS (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,400 kg (5,291 lb)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 3,350 kg (7,385 lb)Traktorenlexikon, “New Holland TL80” | AheadThe New Holland TL 80 (A) has 40% more lift (950 kg / 2,094 lb) than the Deutz-Fahr DX 3.80 AS (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 3,300 kg (7,275 lb)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 4,150 kg (9,149 lb)Traktorenlexikon, “New Holland TL80” | Ahead (a fact, not an advantage)The New Holland TL 80 (A) is 26% heavier (850 kg / 1,874 lb) than the Deutz-Fahr DX 3.80 AS (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 4,000 kg (8,818 lb)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 5,200 kg (11,464 lb)Traktorenlexikon, “New Holland TL80” | AheadThe New Holland TL 80 (A) has 30% higher maximum permissible mass (1,200 kg / 2,646 lb) than the Deutz-Fahr DX 3.80 AS (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 16Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 20 to 24Traktorenlexikon, “New Holland TL80” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | YesTraktorenlexikon, “New Holland TL80” | No figureNo call on a creeper range: not stated for the DX 3.80 AS. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “New Holland TL80” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 540/540E/1000 rpmTraktorenlexikon, “New Holland TL80” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr DX 3.80 AS” | independentTraktorenlexikon, “New Holland TL80” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 2WD / 4WDTraktorenlexikon, “New Holland TL80” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1985–1990 | 1998–2004 | Ahead (a fact, not an advantage)The New Holland TL 80 (A) is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The New Holland TL 80 (A) has 50% more hydraulic flow (20.0 L/min / 5.3 gpm) than the Deutz-Fahr DX 3.80 AS (both pump flow, as stated by the source).
- The New Holland TL 80 (A) has 40% more lift (950 kg / 2,094 lb) than the Deutz-Fahr DX 3.80 AS (both lift at the hitch ends, as stated by the source).
- The New Holland TL 80 (A) is 26% heavier (850 kg / 1,874 lb) than the Deutz-Fahr DX 3.80 AS (both unladen weight, as stated by the source).
- The New Holland TL 80 (A) has 30% higher maximum permissible mass (1,200 kg / 2,646 lb) than the Deutz-Fahr DX 3.80 AS (both maximum permissible mass, as stated by the source).
- The New Holland TL 80 (A) is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power and a creeper range.
← Every figure for both machines, side by side, with sources