6 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 3.80 AS1985–1990No measured PTO figureTractor twoMassey Ferguson 294 AS1980–1987No measured PTO figure
Which should you choose?
Read our verdict on the DX 3.80 AS and the 294 AS → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | DX 3.80 AS | 294 AS | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74 hp | 74 hp | — |
| Engine declared | KHD F4L 913 | — | — |
| Displacement declared | 4.09 L | — | — |
| Maximum torque declared | 192 lb·ft · 260 N·m | 204 lb·ft · 277 N·m | +7% 294 AS |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Independent dry double clutch | Dual dry clutch, independent PTO clutch hand-operated | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 10.6 gpm · 40.0 L/min | — | — |
| Pressure declared | 3,481 psi · 240 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,275 lb · 3,300 kg | 7,121 lb · 3,230 kg | — |
| Maximum permissible mass declared | 8,818 lb · 4,000 kg | 11,023 lb · 5,000 kg | +25% 294 AS |
| Wheelbase declared | 88.6 in · 2,250 mm | 97.6 in · 2,480 mm | +10% 294 AS |
| Length declared | 148.8 in · 3,780 mm | 157.1 in · 3,990 mm | +6% 294 AS |
| Width declared | 74.4 in · 1,890 mm | 78.0 in · 1,980 mm | — |
| Ground clearance declared | 13.4 in · 340 mm | 15.7 in · 400 mm | +18% 294 AS |
| Fuel tank declared | 100.4 qt · 95 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 3.80 AS sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.80 AS”
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.90”
Massey Ferguson 294 AS sources
- Source: Traktorenlexikon, “Massey Ferguson MF 294S”