6 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 3.701984–1989No measured PTO figureTractor twoLandini R-7500 (DT)1978–1987No measured PTO figure
Which should you choose?
Read our verdict on the DX 3.70 and the R-7500 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | DX 3.70 | R-7500 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | KHD F4L 912 | Perkins LD.22756 (A 4.236) | differs |
| Displacement declared | 3.77 L | 3.87 L | — |
| Maximum torque declared | 173 lb·ft · 234 N·m | 198 lb·ft · 268 N·m | +15% R-7500 (DT) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | independent dry double clutch | Dry LUK double clutch, pedal-operated driving clutch and hand lever-operated PTO clutch | differs |
| Hydraulics & hitch | |||
| Pressure declared | 3,481 psi · 240 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,923 lb · 3,140 kg | 6,896 lb · 3,128 kg | — |
| Maximum permissible mass declared | 11,023 lb · 5,000 kg | — | — |
| Wheelbase declared | 91.6 in · 2,327 mm | 96.9 in · 2,460 mm | +6% R-7500 (DT) |
| Length declared | 153.9 in · 3,910 mm | 150.8 in · 3,830 mm | — |
| Width declared | 84.2 in · 2,138 mm | 77.6 in · 1,970 mm | +9% DX 3.70 |
| Ground clearance declared | 18.0 in · 457 mm | 17.7 in · 450 mm | — |
| Turning radius, braked declared | — | 11.2 ft · 3.42 m | — |
| Fuel tank declared | 100.4 qt · 95 L | 64.5 qt · 61.0 L | +56% DX 3.70 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 3.70 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.70”
- Source: Traktorenlexikon, “Deutz D 6006”
Landini R-7500 (DT) sources
- Source: Traktorenlexikon, “Landini 7550”