Deutz-Fahr DX 3.65 vs Fiat 70-86 (DT)

13 material differences

Tractor one

1987–1996

No measured PTO figure

Tractor two

1992–2000

No measured PTO figure

Which should you choose?

Read our verdict on the DX 3.65 and the 70-86 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

13 material differences · 2 fields identical or within 5%, which is not counted as material

Deutz-Fahr DX 3.65 and Fiat 70-86 (DT), field by field
Field	DX 3.65	70-86 (DT)	Gap
Engine
Engine power, claimed claimed	69.1 hp	69.1 hp	—
Engine declared	KHD F4L 912	FIAT-IVECO 8045.06.208 (309)	differs
Displacement declared	3.77 L	3.61 L	—
Maximum torque declared	180 lb·ft · 244 N·m	—	—
Transmission
Top speed declared	24.9 mph · 40 km/h	18.6 mph · 30 km/h	+33% DX 3.65
Clutch declared	independent dry double clutch	—	—
Hydraulics & hitch
Hydraulic control declared	Constant flow	—	—
Pump flow declared	11.3 gpm · 42.6 L/min	10.6 gpm · 40.0 L/min	+7% DX 3.65
Pressure declared	3,481 psi · 240 bar	3,118 psi · 215 bar	+12% DX 3.65
Three-point lift at ends declared	7,275 lb · 3,300 kg	5,236 lb · 2,375 kg	+39% DX 3.65
Rear PTO speeds declared	540/1000 rpm	540 rpm	differs
Weight & dimensions
Unladen weight declared	7,496 lb · 3,400 kg	4,292 lb · 1,947 kg	+75% DX 3.65
Maximum permissible mass declared	11,023 lb · 5,000 kg	—	—
Wheelbase declared	88.6 in · 2,250 mm	77.1 in · 1,959 mm	+15% DX 3.65
Length declared	150.4 in · 3,820 mm	133.5 in · 3,390 mm	+13% DX 3.65
Width declared	85.9 in · 2,183 mm	60.6 in · 1,540 mm	+42% DX 3.65
Height declared	101.6 in · 2,580 mm	79.9 in · 2,029 mm	+27% DX 3.65
Ground clearance declared	16.1 in · 408 mm	15.0 in · 380 mm	+7% DX 3.65
Turning radius, braked declared	15.1 ft · 4.60 m	—	—
Fuel tank declared	76.1 qt · 72 L	47.6 qt · 45.0 L	+60% DX 3.65

Source

Source