Deutz-Fahr DX 3.65 vs Deutz (KHD) Intrac 2004

11 material differences · fewer than 12

Tractor one

1987–1996

No measured PTO figure

Tractor two

1978–1989

No measured PTO figure

Which should you choose?

Read our verdict on the DX 3.65 and the Intrac 2004 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

11 material differences · 5 fields identical or within 5%, which is not counted as material

Deutz-Fahr DX 3.65 and Deutz (KHD) Intrac 2004, field by field
Field	DX 3.65	Intrac 2004	Gap
Engine
Engine power, claimed claimed	69.1 hp	68.7 hp	—
Engine declared	KHD F4L 912	KHD F4L 912 H	differs
Displacement declared	3.77 L	3.77 L	—
Maximum torque declared	180 lb·ft · 244 N·m	175 lb·ft · 237 N·m	—
Transmission
Top speed declared	24.9 mph · 40 km/h	18.6–24.9 mph · 30–40 km/h	differs
Clutch declared	independent dry double clutch	—	—
Hydraulics & hitch
Hydraulic centre declared	—	Open centre	—
Hydraulic control declared	Constant flow	—	—
Pump flow declared	11.3 gpm · 42.6 L/min	12.4 gpm · 47.1 L/min	+11% Intrac 2004
Pressure declared	3,481 psi · 240 bar	2,538 psi · 175 bar	+37% DX 3.65
Three-point lift at ends declared	7,275 lb · 3,300 kg	5,291 lb · 2,400 kg	+38% DX 3.65
Rear PTO speeds declared	540/1000 rpm	540/1000 rpm	—
Weight & dimensions
Unladen weight declared	7,496 lb · 3,400 kg	7,055 lb · 3,200 kg	+6% DX 3.65
Maximum permissible mass declared	11,023 lb · 5,000 kg	11,795 lb · 5,350 kg	+7% Intrac 2004
Wheelbase declared	88.6 in · 2,250 mm	86.6 in · 2,200 mm	—
Length declared	150.4 in · 3,820 mm	140.2 in · 3,560 mm	+7% DX 3.65
Width declared	85.9 in · 2,183 mm	79.7 in · 2,025 mm	+8% DX 3.65
Height declared	101.6 in · 2,580 mm	108.7 in · 2,760 mm	+7% Intrac 2004
Ground clearance declared	16.1 in · 408 mm	14.0 in · 355 mm	+15% DX 3.65
Turning radius, braked declared	15.1 ft · 4.60 m	—	—
Fuel tank declared	76.1 qt · 72 L	—	—

Source

Source