10 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 3.301984–1996No measured PTO figureTractor twoFiat 600 (TD)1971–1973No measured PTO figure
Which should you choose?
Read our verdict on the DX 3.30 and the 600 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | DX 3.30 | 600 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 54 hp | 59.1 hp | +10% 600 (TD) |
| Engine declared | KHD F3L 912 | FIAT-IVECO 8045.02.200 | differs |
| Displacement declared | 2.83 L | 3.46 L | +22% 600 (TD) |
| Maximum torque declared | 119 lb·ft · 162 N·m | 147 lb·ft · 199 N·m | +23% 600 (TD) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | Independent dry double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.0 gpm · 38.0 L/min | — | — |
| Pressure declared | 3,481 psi · 240 bar | 2,843 psi · 196 bar | +22% DX 3.30 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,019 lb · 2,730 kg | 4,663 lb · 2,115 kg | +29% DX 3.30 |
| Wheelbase declared | 79.2 in · 2,012 mm | 81.5 in · 2,070 mm | — |
| Length declared | 137.4 in · 3,490 mm | 135.0 in · 3,430 mm | — |
| Width declared | 72.8 in · 1,848 mm | 70.9–95.3 in · 1,800–2,420 mm | differs |
| Ground clearance declared | 16.1 in · 410 mm | 17.6 in · 447 mm | +9% 600 (TD) |
| Turning radius, braked declared | — | 11.2 ft · 3.42 m | — |
| Fuel tank declared | 87.7 qt · 83 L | 57.1 qt · 54.0 L | +54% DX 3.30 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 3.30 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.30”
- Source: Traktorenlexikon, “Deutz D 4006 P”
Fiat 600 (TD) sources
- Source: Traktorenlexikon, “Fiat 600/600 DT”
- Source: Traktorenlexikon, “Someca 600”