11 material differences · fewer than 12
Tractor oneDeutz-Fahr D 36071982–1988No measured PTO figureTractor twoSOMECA 400 (DT)1968–1971No measured PTO figure
Which should you choose?
Read our verdict on the D 3607 and the 400 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 3607 | 400 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34 hp | 34 hp | — |
| Engine declared | KHD F2L 912 | O.M.-FIAT 8035.01.201 | differs |
| Displacement declared | 1.88 L | 2.34 L | +24% 400 (DT) |
| Maximum torque declared | 86 lb·ft · 117 N·m | 103 lb·ft · 140 N·m | +20% 400 (DT) |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 15.5 mph · 25 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 9.2 gpm · 35 L/min | 5.8 gpm · 21.8 L/min | +61% D 3607 |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Three-point lift, at the coupling points declared | 4,189 lb · 1,900 kg | 2,866 lb · 1,300 kg | +46% D 3607 |
| Rear PTO speeds declared | 600 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,255 lb · 1,930 kg | 3,748 lb · 1,700 kg | +14% D 3607 |
| Maximum permissible mass declared | 7,055 lb · 3,200 kg | — | — |
| Wheelbase declared | 73.4 in · 1,865 mm | 75.6 in · 1,920 mm | — |
| Length declared | 131.1 in · 3,330 mm | 126.0 in · 3,200 mm | — |
| Width declared | 63.0 in · 1,600 mm | 62.4–88.2 in · 1,585–2,240 mm | differs |
| Ground clearance declared | 18.1 in · 460 mm | 14.6 in · 370 mm | +24% D 3607 |
| Turning radius, braked declared | — | 9.7 ft · 2.95 m | — |
| Fuel tank declared | 74.0 qt · 70 L | 57.1 qt · 54.0 L | +30% D 3607 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr D 3607 sources
- Source: Traktorenlexikon, “Deutz-Fahr D 3607”
- Source: Traktorenlexikon, “Deutz D 2506”
SOMECA 400 (DT) sources
- Source: Traktorenlexikon, “Someca 400”