Deutz-Fahr AgroXtra 3.57 or Fiat 65-56 LM (DT)?
Which should you choose?
On performance, every comparable figure that differs favours the Deutz-Fahr AgroXtra 3.57: hydraulic flow and three-point lift. It is also ahead on forward gears and PTO speeds.
- The Deutz-Fahr AgroXtra 3.57 suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 750, 1000 rpm.
- The Deutz-Fahr AgroXtra 3.57 suits loader and hydraulic implement work better on this data: 16% (5.2 L/min / 1.4 gpm) more hydraulic flow and 38% (655 kg / 1,444 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | AgroXtra 3.57 | 65-56 LM (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 40.3 kW (54.0 hp)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | 39.9 kW (53.5 hp)Traktorenlexikon, “Fiatagri 65-56 LM (DT)” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the AgroXtra 3.57 and the 65-56 LM (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the AgroXtra 3.57 and the 65-56 LM (DT). |
| Which pumps more oil for implements? | 38.0 L/min (10.0 gpm)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | 32.8 L/min (8.7 gpm)Traktorenlexikon, “Fiatagri 65-56 LM (DT)” | AheadThe Deutz-Fahr AgroXtra 3.57 has 16% more hydraulic flow (5.2 L/min / 1.4 gpm) than the Fiat 65-56 LM (DT) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,400 kg (5,291 lb)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | 1,745 kg (3,847 lb)Traktorenlexikon, “Fiatagri 65-56 LM (DT)” | AheadThe Deutz-Fahr AgroXtra 3.57 has 38% more lift (655 kg / 1,444 lb) than the Fiat 65-56 LM (DT) (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 3,290 kg (7,253 lb)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | 2,270 kg (5,004 lb)Traktorenlexikon, “Fiatagri 65-56 LM (DT)” | Ahead (a fact, not an advantage)The Deutz-Fahr AgroXtra 3.57 is 45% heavier (1,020 kg / 2,249 lb) than the Fiat 65-56 LM (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 4,500 kg (9,921 lb)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | — | No figureNo call on maximum permissible mass: no figure on record for the 65-56 LM (DT). |
| Which has the wider choice of gears? | 16Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | 8 to 12Traktorenlexikon, “Fiatagri 65-56 LM (DT)” | AheadThe Deutz-Fahr AgroXtra 3.57 has 33% more forward gears (4 gears) than the Fiat 65-56 LM (DT) (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the AgroXtra 3.57 and the 65-56 LM (DT). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | 30 km/h (18.6 mph)Traktorenlexikon, “Fiatagri 65-56 LM (DT)” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000/750 rpmTraktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | 540 rpmTraktorenlexikon, “Fiatagri 65-56 LM (DT)” | AheadThe Deutz-Fahr AgroXtra 3.57 offers 750 and 1000 rpm at the PTO, which the Fiat 65-56 LM (DT) does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | independentTraktorenlexikon, “Fiatagri 65-56 LM (DT)” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr AgroXtra 3.57” | Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri 65-56 LM (DT)” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1991–1996 | 1988– | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz-Fahr AgroXtra 3.57 has 16% more hydraulic flow (5.2 L/min / 1.4 gpm) than the Fiat 65-56 LM (DT) (both pump flow, as stated by the source).
- The Deutz-Fahr AgroXtra 3.57 has 38% more lift (655 kg / 1,444 lb) than the Fiat 65-56 LM (DT) (both lift at the hitch ends, as stated by the source).
- The Deutz-Fahr AgroXtra 3.57 is 45% heavier (1,020 kg / 2,249 lb) than the Fiat 65-56 LM (DT) (both unladen weight, as stated by the source).
- The Deutz-Fahr AgroXtra 3.57 has 33% more forward gears (4 gears) than the Fiat 65-56 LM (DT) (both forward gears, as stated by the source).
- The Deutz-Fahr AgroXtra 3.57 offers 750 and 1000 rpm at the PTO, which the Fiat 65-56 LM (DT) does not (as stated by the sources).
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources