7 material differences · fewer than 12

Tractor oneDeutz-Fahr Agrotron X 7202006–2013No measured PTO figureTractor twoJohn Deere 77101997–2003151.4 hpMeasured at the PTO · OECD Test 1709

Which should you choose?

We will not advise between these two machines, because their power is not stated as the same quantity on both; their unladen weight differs by more than 25% (57%); the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (2006–2013; 1997–2003). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

7 material differences · 2 fields identical or within 5%, which is not counted as material

Deutz-Fahr Agrotron X 720 and John Deere 7710, field by field
FieldAgrotron X 7207710Gap
Measured performance
PTO power, measured measured—151.4 hp—
Drawbar power, measured measured—137.5 hp—
Engine
Engine declared—John Deere 6.081 TRW-02—
Displacement declared—8.13 L—
Maximum torque declared—497 lb·ft · 674.0 N·m—
Transmission
Top speed declared24.9–31.1 mph · 40–50 km/h18.6–31.1 mph · 30–50 km/hdiffers
Hydraulics & hitch
Hydraulic centre declared—Closed centre—
Hydraulic control declaredLoad sensingLoad sensing—
Pump flow declared—26.8 gpm · 101.4 L/min—
Rear PTO speeds declared540 rpm / 750 rpm / 1000 rpm540/1000 rpmdiffers
Weight & dimensions
Unladen weight declared20,790–23,005 lb · 9,430–10,435 kg13,278–15,448 lb · 6,023–7,007 kgdiffers
Maximum permissible mass declared30,865 lb · 14,000 kg25,353 lb · 11,500 kg+22% Agrotron X 720
Wheelbase declared121.9 in · 3,095 mm110.2–114.2 in · 2,800–2,900 mmdiffers
Length declared207.4 in · 5,268 mm187.2 in · 4,755 mm+11% Agrotron X 720
Width declared108.3 in · 2,750 mm108.3 in · 2,750 mm—
Ground clearance declared19.4–21.6 in · 494–548 mm20.3 in · 515 mmdiffers
Turning radius, braked declared22.1 ft · 6.75 m——
Fuel tank declared—285.9 qt · 270.6 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr Agrotron X 720 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agrotron X 720”

John Deere 7710 sources

Source
  • Source: OECD test report 1709, 1997
  • Source: Traktorenlexikon, “John Deere 7810”
  • Source: Traktorenlexikon, “John Deere 7710”