7 material differences · fewer than 12
Tractor oneDeutz-Fahr Agrotron 6150from 2012No measured PTO figureTractor twoJohn Deere 69101997–2003No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2012–2012; 1997–2003). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Agrotron 6150 | 6910 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 135 hp | 133.3 hp | — |
| Engine declared | Deutz AG TCD 6.1 L06 4V | John Deere POWER-TECH 6.068 TLA 52 | differs |
| Displacement declared | 6.06 L | 6.79 L | +12% 6910 |
| Maximum torque declared | 446 lb·ft · 605 N·m | 423 lb·ft · 573 N·m | +6% Agrotron 6150 |
| Transmission | |||
| Top speed declared | — | 18.6–31.1 mph · 30–50 km/h | — |
| Clutch declared | — | Pedal-operated, hydraulic wet Perma-Clutch II designed as a multi-plate clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Closed centre | differs |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 21.9 gpm · 83.0 L/min | — | — |
| Pressure declared | — | 435–3,002 psi · 30–207 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540E/540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,655 lb · 5,740 kg | 13,503 lb · 6,125 kg | +7% 6910 |
| Maximum permissible mass declared | — | 22,046 lb · 10,000 kg | — |
| Wheelbase declared | 104.2 in · 2,647 mm | 104.3 in · 2,650 mm | — |
| Length declared | 184.5 in · 4,686 mm | 179.6 in · 4,563 mm | — |
| Width declared | 98.4 in · 2,500 mm | 96.1 in · 2,440 mm | — |
| Ground clearance declared | — | 18.9 in · 480 mm | — |
| Fuel tank declared | 295.9 qt · 280 L | 264.2 qt · 250.0 L | +12% Agrotron 6150 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agrotron 6150 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 6150”
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 7250”
John Deere 6910 sources
- Source: Traktorenlexikon, “John Deere 6910”
- Source: OECD test report 1824, 1999