6 material differences · fewer than 12
Tractor oneDeutz-Fahr AgroStar 6.281993–1995No measured PTO figureTractor twoFendt Favorit 511 C1994–1999No measured PTO figure
Which should you choose?
Read our verdict on the AgroStar 6.28 and the Favorit 511 C → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | AgroStar 6.28 | Favorit 511 C | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 113.5 hp | 112.9 hp | — |
| Engine declared | KHD F6L 913 | MWM D 226 | differs |
| Displacement declared | 6.13 L | 6.23 L | — |
| Maximum torque declared | 257 lb·ft · 348 N·m | 336 lb·ft · 456 N·m | +31% Favorit 511 C |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | dry single clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 14.5 gpm · 55.0 L/min | 27.5 gpm · 104.0 L/min | +89% Favorit 511 C |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540/1000/750 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 10,229 lb · 4,640 kg | 11,684 lb · 5,300 kg | +14% Favorit 511 C |
| Maximum permissible mass declared | 18,739 lb · 8,500 kg | — | — |
| Wheelbase declared | 107.0 in · 2,718 mm | 101.9 in · 2,589 mm | — |
| Length declared | 179.4 in · 4,556 mm | 174.6 in · 4,435 mm | — |
| Width declared | 97.2 in · 2,470 mm | 93.7 in · 2,380 mm | — |
| Ground clearance declared | 20.9 in · 530 mm | 21.1 in · 536 mm | — |
| Turning radius, braked declared | — | 14.4 ft · 4.40 m | — |
| Fuel tank declared | 179.6 qt · 170 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr AgroStar 6.28 sources
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”
- Source: Traktorenlexikon, “Deutz-Fahr DX 120”
Fendt Favorit 511 C sources
- Source: Traktorenlexikon, “Fendt Favorit 511 C”