6 material differences · fewer than 12
Tractor oneDeutz-Fahr AgroStar 4.781993–1995No measured PTO figureTractor twoJohn Deere 3350 (A)1986–1993No measured PTO figure
Which should you choose?
Read our verdict on the AgroStar 4.78 and the 3350 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | AgroStar 4.78 | 3350 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 98.7 hp | 98.7 hp | — |
| Engine declared | KHD BF4L 913 | John Deere 6.359 DL-009 | differs |
| Displacement declared | 4.09 L | 5.88 L | +44% 3350 (A) |
| Maximum torque declared | 285 lb·ft · 387 N·m | 292 lb·ft · 396 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | — | Pedal-operated dry LuK single-plate clutch as drive clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 13.8 gpm · 52.3 L/min | — |
| Pressure declared | — | 3,336 psi · 230 bar | — |
| Rear PTO speeds declared | 540/1000/750 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,259 lb · 4,200 kg | 9,315 lb · 4,225 kg | — |
| Maximum permissible mass declared | 16,535 lb · 7,500 kg | 14,771 lb · 6,700 kg | +12% AgroStar 4.78 |
| Wheelbase declared | 96.5 in · 2,450 mm | 100.4 in · 2,551 mm | — |
| Length declared | 168.2 in · 4,272 mm | 175.8 in · 4,465 mm | — |
| Width declared | 90.2 in · 2,290 mm | 88.5 in · 2,249 mm | — |
| Ground clearance declared | 18.3 in · 465 mm | 25.6 in · 650 mm | +40% 3350 (A) |
| Fuel tank declared | 139.5 qt · 132 L | 127.9–182.8 qt · 121.0–173.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr AgroStar 4.78 sources
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 4.78”
John Deere 3350 (A) sources
- Source: Traktorenlexikon, “John Deere 3350”