Deutz-Fahr DX 4.61 or SAME Explorer 90 II (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the DX 4.61 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Explorer 90 II (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | DX 4.61 | Explorer 90 II (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 65 kW (87 hp)Traktorenlexikon, “Deutz-Fahr AgroStar 4.61” | 64.7 kW (86.8 hp)Traktorenlexikon, “SAME Explorer II 90” | Not comparableNot comparable on power at the PTO shaft: the DX 4.61 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Explorer 90 II (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the DX 4.61 and the Explorer 90 II (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the DX 4.61 and the Explorer 90 II (DT). |
| Which pumps more oil for implements? | — | 35.8 L/min (9.5 gpm)Traktorenlexikon, “SAME Explorer II 90” | No figureNo call on hydraulic flow: no figure on record for the DX 4.61. |
| Which lifts more on the three-point hitch? | 3,800 kg (8,378 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 4.61” | — | No figureNo call on three-point lift: no figure on record for the Explorer 90 II (DT). |
| Which is heavier, for traction? | 4,150 kg (9,149 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 4.61” | 3,110 kg (6,856 lb)Traktorenlexikon, “SAME Explorer II 90” | Ahead (a fact, not an advantage)The Deutz-Fahr DX 4.61 is 33% heavier (1,040 kg / 2,293 lb) than the SAME Explorer 90 II (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 7,500 kg (16,535 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 4.61” | — | No figureNo call on maximum permissible mass: no figure on record for the Explorer 90 II (DT). |
| Which has the wider choice of gears? | 18Traktorenlexikon, “Deutz-Fahr AgroStar 4.61” | 15 to 20Traktorenlexikon, “SAME Explorer II 90” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the DX 4.61 and the Explorer 90 II (DT). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroStar 4.61” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “SAME Explorer II 90” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000/750 rpmTraktorenlexikon, “Deutz-Fahr AgroStar 4.61” | 540/540E/1000E/1000 rpmTraktorenlexikon, “SAME Explorer II 90” | AheadThe Deutz-Fahr DX 4.61 offers 750 rpm at the PTO, which the SAME Explorer 90 II (DT) does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr AgroStar 4.61” | independentTraktorenlexikon, “SAME Explorer II 90” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr AgroStar 4.61” | Two-wheel or four-wheel driveTraktorenlexikon, “SAME Explorer II 90” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1990–1993 | 1989–1998 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz-Fahr DX 4.61 is 33% heavier (1,040 kg / 2,293 lb) than the SAME Explorer 90 II (DT) (both unladen weight, as stated by the source).
- The Deutz-Fahr DX 4.61 offers 750 rpm at the PTO, which the SAME Explorer 90 II (DT) does not (as stated by the sources).
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the DX 4.61 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Explorer 90 II (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources