Deutz-Fahr AgroPrima 6.16 or Deutz-Fahr DX 6.30?
Which should you choose?
On performance, every comparable figure that differs favours the Deutz-Fahr AgroPrima 6.16: maximum permissible mass. It is also ahead on PTO speeds.
- The Deutz-Fahr AgroPrima 6.16 suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 750 rpm.
- The Deutz-Fahr AgroPrima 6.16 suits road haulage better on this data: 10% (700 kg / 1,543 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | AgroPrima 6.16 | DX 6.30 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 76 kW (102 hp)Traktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | 75.5 kW (101.2 hp)Traktorenlexikon, “Deutz-Fahr DX 6.30” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the AgroPrima 6.16 and the DX 6.30. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the AgroPrima 6.16 and the DX 6.30. |
| Which pumps more oil for implements? | — | 60.4 L/min (16.0 gpm)Traktorenlexikon, “Deutz-Fahr DX 6.30” | No figureNo call on hydraulic flow: no figure on record for the AgroPrima 6.16. |
| Which lifts more on the three-point hitch? | 5,200 kg (11,464 lb)Traktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | 5,200 kg (11,464 lb)Traktorenlexikon, “Deutz-Fahr DX 6.30” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 4,450 kg (9,811 lb)Traktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | 4,840 kg (10,670 lb)Traktorenlexikon, “Deutz-Fahr DX 6.30” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 7,500 kg (16,535 lb)Traktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | 6,800 kg (14,991 lb)Traktorenlexikon, “Deutz-Fahr DX 6.30” | AheadThe Deutz-Fahr AgroPrima 6.16 has 10% higher maximum permissible mass (700 kg / 1,543 lb) than the Deutz-Fahr DX 6.30 (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 15 to 18Traktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | 15 to 18Traktorenlexikon, “Deutz-Fahr DX 6.30” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the AgroPrima 6.16 and the DX 6.30. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr DX 6.30” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000/750 rpmTraktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | 540/1000 rpmTraktorenlexikon, “Deutz-Fahr DX 6.30” | AheadThe Deutz-Fahr AgroPrima 6.16 offers 750 rpm at the PTO, which the Deutz-Fahr DX 6.30 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | independentTraktorenlexikon, “Deutz-Fahr DX 6.30” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr AgroPrima 6.16” | Two-wheel or four-wheel driveTraktorenlexikon, “Deutz-Fahr DX 6.30” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1992–1995 | 1983–1990 | Ahead (a fact, not an advantage)The Deutz-Fahr AgroPrima 6.16 is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz-Fahr AgroPrima 6.16 has 10% higher maximum permissible mass (700 kg / 1,543 lb) than the Deutz-Fahr DX 6.30 (both maximum permissible mass, as stated by the source).
- The Deutz-Fahr AgroPrima 6.16 offers 750 rpm at the PTO, which the Deutz-Fahr DX 6.30 does not (as stated by the sources).
- The Deutz-Fahr AgroPrima 6.16 is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow and a creeper range.
← Every figure for both machines, side by side, with sources